Recent content by jamesfillmore

If anyone has at least 2 of the 6001786 clips I can HAVE, I'll have those made. There are a few clips that have never been reproduced (64 & 65 B bodies especially - still looking for samples of those. No one wants to give them up) and quite a few that are now discontinued. I just went to...

Hey Joe Can you contact me. Your inbox is full and I dont want to pose any info on here so the spambots can grab it.

Hey Joe, Can you shoot me at email about the screws. Did I ask you about all the rubber body bumpers too? Thanks!

Have any sill plate screws from either of these cars?

Need one for a reference. I'd pay for shipping (can cut in 1/2) and I'd send a new one for free. Thanks! Jim Fillmore Detroit Muscle Technologies

Have a trunk divider? The black cardboard piece behind the rear seat? I need one for a pattern.

Looking for the black cardboard trunk divider board. Also interested in the lower window channels (both front and rear) with the flocked rubber liners. Jim Fillmore Detroit Muscle Technologies Shoot me a message

Thanks. Saves me from having to buy a hardtop and sedan vent window to learn the hard way :)

Since the vent window glass is the same on all (sedan & hardtop) 64 & 65 vent windows according to AMD glass website, would that mean the vent window seals listed for sedans would also fit hardtops? If not what manufacture carries a hardtop specific vent window seal? Same for 62-63, since the...

Sorry for the crappy photo but this is my 62-65 B Body (?) trunk divider in a 64 330 2dht. You can see it's about 4" too narrow overall and about 4" or more too short. Maybe shorter if its supposed to ave a cutout over the trans tunnel.

Thanks Andy! Can you share a picture and compare to the measurements i posted above. On the I make there are small cutouts on each side. I can see in a picture of a 62 Polara that there are wheelwell seams in that area. Ill have to stop by my buddies shop. He put this one in his 64 330 2dht and...

That does look right. 8 holes (as opposed to 7 non symmetrical holes in 63-65 hood to rad seals). Cutout for the hood latch. BUT it doesn't look like the wider/flatter ones in the 2 pictures I have. Also that wouldn't seal against your rad support. In your picture it looks like the holes in the...

Darn. Thanks for checking. ALL the cars in that 62 ONLY post and I can't find a hood seal to duplicate.

Attached is another picture of a car for sale with the same hood seal.

Many people are selling the 63-65 hood too radiator seal that mounts on the rad support as fitting a 62. Even Steele rubber. I don't think anyone is selling the one I show in my picture above that is 62 B only. I know Joe. I'll call him tomorrow but I'd bet he doesn't have the one in the picture...