Recent content by jamr

Classic Industries has Cylinder head and Water Pump Bolts for my small block 318. Anyone have another source or are the ones I found a good purchase?

Thinking I asked a simple or dum question or both, I worked on the wheel wells and finished up both sides this weekend. Marks a big accomplishment as All metal work is done.

On the rear wheel well of a 74 RR, what is the width moving from the middle to the bottom? See the pictures below to illustrate my question. Second question is how far does the wheel well lip travel to the end. The third picture shows a square metal piece. Should it travel that far or...

Good question. It is a Roadrunner. I need help with whether the outside bevel follows the fender well to the bottom. Attached is where I am at. Car is obviously in this picture upside down

Would someone be willing to post a few pictures of the rear outside fender well closest to the door? I want to see how the lip finishes out as it nears the bottom of the car. Also a picture of of the inside of the fender well in the same location. I'm fabricating this outside lip due to rust...

Please share your experience with the Auto Metal Direct Lower Rear Quarter Panel patch. Fit well? Good quality? Thanks.

Anyone know where to buy new the rear inside panel for a 74 Roadrunner? The outside Quarter Panel is repairable the the inside is rusted through.

74 Roadrunner Progress I finished the complete tear down and built a rotisserie to aid in the undercoating removal and sandblasting. Fun Times!

Nearly finished building a rotissirie for my 74 Roadrunner and was wondering where it should attach at the rear of the car. I have considered the frame but not certain where to bolt it. The other option is where the bumper mounts to the rear of the trunk. Suggestions and even pictures would...

Probably going to change the color to silver. Family thinks the current color is p^^p brown.

Hey everyone. New member from Kansas and just started the restoration two weeks ago. Tear down has been going well and hope to have the body removed off the frame in a couple of weeks. Been reading all the great posts and plan to tap into expertise as the project continues.