Recent content by John H

Thank you so much Sam. Any suggestions as exactly what I need and where I should buy them?

Tail Shaft numbers

So here are the numbers off of the Transmission and the location of the shifter. I was hoping to move the shifter to the correct location on the hump and install a stock console in the future... Any idea's men? Can use what I have and change the linkage by any chance? Thank you everyone!

Forge numbers in the tran is 99129 H

"C:\Users\Jhart\Downloads\IMG_1235.MOV"

I have a 67 Coronet with a 383 and 4 speed. When I bought it the stick comes out of the floor and is positioned beside the drivers seat. I know it belongs forward of that. Whoever built it hacked a hole in the floor to bring it through. Can someone tell me if it is possible to change the...

Hi All, Can anyone tell me what the correct paint/color my motor should be for a 1967 Dodge Coronet 440 with a 383? I have seen orange and Plymouth/turquoise blue. It's currently orange which I am told is incorrect...

Fuel is new. Smokes after running/all the time basically, Holly 4 barrel (not sure what size) and electronic ignition. Pulled all the plugs. All looked good.

I am getting what appears to be excessive moisture and white/oil smoke out of my right/passenger exhaust. It is a 1967 383 that was built 20 years ago, then sat in a collectors barn until 2 years ago. I drove it on a regular basis (seasonal-Northeast car) since then. Car shows etc... We recently...

ok. I meant I have 15" tires on my car... Sorry.

I saw this very clever..

Hey, Do I need the anti-vibration springs on my 15" brake drums? I have 1 with an original one and one without anything. I am in the middle of putting my rear end bake together etc. If I do, where would you guys recommend I buy them. Thanks, John

Thank you everyone.

Looking for the size speaker we have in the dash of a 67 Coronet. A.M. Radio (of course) I want to replace it with a significant upgrade... Possibly 2-3 1/2" or whatever.