Recent content by johnpblack

It's a project so I haven't put the door panels on yet. I did have a look and noticed that I need a plastic shield between the two. Thanks for the help

Thank you for the explanation! I did think it was odd on why it was like that. I have it all nice and tight and it was still leaking through to the inside of the door. Thanks for answering that for me

It is running through the seal up to the window, and on the point where it clips on to the door. I didn't know if it was a common problem.

Hi, I'm just wondering if anyone else has had some problems I have. My 69 Charger windows on the horizontal seals leak like crazy! I have replaced the seals all around and still can not stop the leaking. Any advice on this, please? Thank you!

Hi, Could anyone help me. I am struggling to wire my wipers and washer pump. It's the 2 speed does anyone have a picture of the wiper motor wired in and the dash wiring? Thanks for any help.

Hi. I'm just wiring my charger with a painless wiring loom. I have everything working, but the gauges. Do you happen to have pictures from the back of the dash? Just trying to find out where I have gone wrong.

Hi, I hope someone can help. I'm struggling with my ignition leads on the passenger side. The straight boots are hitting the side and touching on the headers. I am looking for elbows on both ends 8.5mm Does anybody know where I can get them pre assembled for my 440 please? Also, I am...

That would be great. I have most of the wiring done I am just onto the gauges I can't seem to get them to work. Any info would be much appreciated Thanks.

The wires are labeled but it's to what goes where on the back of the dash. What wires have to be spliced. What is the main power source to the back. Sorry I'm a complete novice with wiring. Problem is I have already bought and started installing a complete new painless wiring harness.

Hi people. Has anyone else used a painless wiring loom? I'm now on to wiring the dash. I did not have the old loom to copy, and the painless diagram has not been helpful with the dash. If anybody has pictures of the back of theirs or what wires go to where that would be great. Much appreciated

Yeah, that's what I expected it to be, but it had new floor pans before. The holes have not come pre drilled. Just wanted to check before I started to make holes

Hi everyone. I was just wondering if anyone can help me. I'm now installing the front seats on my 69 charger. I did not remove them.so I have no idea how they go back in. Any pictures of how they go back in would be much appreciated! Thanks!

Working progress!

My build slowly coming together!

So, I have got the new head bolts but when I spoke to Edelbrock, they said that I needed new push rods if I wanted to use these. I wasn't sure if they were just trying to get me to spend more.