LemonWedge's latest activity
-
During my dealership days I was the suspension guy. Worked very closely with our body shop doing the parts replacement on a lot of... -
I would replace the whole front clip as a fresh start. It may take more time and effort, probably forfeiting at least part of the next...
-
The tech's at the shop I managed would always to pulls on a vehicle before un-zipping mangled sections. This would get the inner...
-
Are there any of those 67's that came with a dash pad delete? Is the original dash straight? Don't want to seem like I'm spending your...
-
LemonWedge replied to the thread Rebuilding LemonWedge..Pretty sobering video, Doug. I had already identified a hole drilled low in the firewall that I’m pretty sure I cut decades ago to pass...
-
-
I tack welded block off panels over all of my heater blower motor, heater hose holes and any other factory holes not being used. If you...
-
LemonWedge replied to the thread Rebuilding LemonWedge..Current plan is simply make a few small sheetmetal patch panels and apply from the backside with 2-part epoxy. It’s not an AC car, so...
-
I agree.
-
LemonWedge replied to the thread Rebuilding LemonWedge..You’ll recall from earlier I had thought that perhaps the pass. Side frame rail was straight…. Measuring the same points from the...
-
LemonWedge replied to the thread Rebuilding LemonWedge..I spent a decent amount of time yesterday laying on my back with a tape measure in my hands looking at measurements from the back of the...
-
As a former drag racer, I was saddened to hear about your accident. I don't have much to add to the discussion but I have been...
-
LemonWedge replied to the thread Rebuilding LemonWedge..I think the motorplate is the direction we’ll be going, Malex. Yeah, this was a bad deal. I pretty much took the entire summer away...
-
-
This is the first that I’m aware of your accident LW. Tough break. Damn. Glad that you walked away and OK. Bad news on LW though but...
-
It's going to be faster than it was. That's enough to keep you moving it ahead.
-
Use the 3 prong neutral safety switch. Connecting the outer 2 pins to power and the reverse lights will activate them. I was all...
