Recent content by leutdan

you guys are hilarious

Thanks for the responses. mopar4don, it could have been something like that, however it was too uniform/straight across the top and had a consistency that seemed to have a strand of fiber like a fabric or rolled material. pnora, I have that product. Do you just string multiple strands of that...

I have some 1/8 inch butyl rubber material that I could cut and make a gasket but that might be too thick and cause misalignment.

Can someone direct me to a source for the material installed between the fenders and frame along the surfaces where the fender bolts and u bolts attach the two. It looked like a black spongy tar/felt material when I took it apart after 50 years of protection. If there is no source for the...

Im guilty dadsbee. Im 72 and this is my first time. If I did something last last month, sometimes I create problems if I forget where a part comes from. Nice work there. I have riveted my rear seal into the frame but am not quite ready to reassemble. Thanks again.

Thank you Charles Cook, dadsbee and R413. Dadsbee, I suppose I could have cut that short piece off of the rear guide channel and forgot having done so. I have the new rear guide channels and they are much longer. Maybe 18-20" before trimming. Thanks again all of you.

Can anyone help find a supplier of these two door glass assembly parts. The black rubber "U" or horseshoe shaped slips over the edge of the door glass. The clear/opaque plastic or mylar piece clips over the edge of the door frame and I believe provides glide protection for the glass. Cannot find...

I will just get the one on eBay for $40. Thanks

I know it has been years since your post about the Paul Herd restoration guide you had for $30. However, I was looking for a copy and I just have to ask, do you still have the copy? I didn't see a response to your offer. And I assume it is in good shape.

I know I am late to this thread, however, this info may be helpful to someone in the future if searching for fasteners and bolts, etc. I have found AMK Fasteners in Winchester, VA to be quite helpful and stocks many original fasteners, etc. Ask for one of their catalogs for Bulk Fasteners and...

Thank you mopar4don. I am all over it

This is a photo of the underside of the trunk from my 1968 Roadrunner. Can you help me with the name of the material injected like a filler and vibration damper between the sheet metal and the support structure on the underside of the hood and trunk at numerous locations. It is not a butyl or...

Thanks gentlemen

Thanks retractable, I will look at that.