Recent content by magvan

Full set of 11x3 front brakes including spindles. these came off of my 1967 r/t. These were regularly driven up until last year, stored inside since. I would think You should be able to bolt them on and drive. $275 I am near Disneyland. If you want them shipped, plan on spending some money...

My answer for you it will depend on the brand of the wheel and how good of aluminum casting they had. I’ve on 42 different brands of aluminum slot mags and I can tell you ansen stay shiny for years I have some no-name ones that were Dull in months

Few more

More pics

putting my 1967 coronet rt up for sale. It is dd1 blue metallic with dark blue interior. 440/727/8 3/4 Car was never been wrecked. Solid floors & rockers. There are bubbles in the rear wheel arches. I’ve owned the car for 7 or 8 years and put 20k miles on it. You can drive it anywhere, I’ve...

haha gas gauge. none of my dodges gas gauges are anywhere close to accurate. 2 of them have nos sending units (1 of which cost $395) the gauges have been tested in all 3 vehicles, and even replaced the dash harness in 1 of them the others i have literally glass beaded every connection. i have...

I’ve tried only oem used and a new old stock senders

I have the same problem in 2 of my dodges. Pulled everything apart, cleaned all connections, tested the gauges and tried different senders and nothing changed on either of mine

My 67 rt is like the top one

california

selling my 1974 D100 Adventurer short bed truck. this truck has a 440 engine, 727 auto trans, factory 8 3/4 rear end, disc brakes, power steering, trans cooler, sway bar & air conditioning, sport mirrors, sport rear bumper the engine is from a highway patrol car. has 63k miles on it, Edelbrock...

Delphi from napa. its just a stock sensor for a gm truck

fitech uses 58 psi so you need a pump capable of more than that. walbro 255 is over 100 psi free flowing and they make bigger more liters per hour pumps too. i ran 3/8 feed and 5/16 return lines but you can run anything bigger than that, it wont hurt going bigger. i only have about 400hp so i...

yes return line to the tank. the best way to do it i ran a stock 440 distributor. i didnt have timing control hooked up. i was always going to but never did