Recent content by Marc##

Thanks to Mark (The Guage Doc) and Greg (RT-Eng) I have a working tach again.

Mark, I will contact you this week. Thanks, Marc

Thanks for the tip. I'll keep my eyes open.

Got it. New and old doesn't always mix well. Thx Still looking for a can for the sending unit if anyone has one.

Bill, I Look forward to hearing from you.

The title says it all for my '66 Charger. If anyone has one they are found behind the glove box on the bottom frame of the dash. I have a new circuit board and connector from the wiring harness.

Thank you, I'll try to find one, just ordered the circuit board from Greg at RT-engineering. Its a start.

Here's a question, see the picture and would you say the circled connector is for the tach circuit board?

Thanks, looks like mine is just gone, screwholes for the bracket are there.

There is no sardine can, anyone have a spare?

Thanks

This picture is very helpful. See mine below. Thanks again.

Thanks, will broaden my search

Tagging on to this thread about Tachs. Looking for ideas on where to go next. See the photo of backside of tach, only one other terminal on left (obstructed) with a yellow wire on it. Also, I do not have a sardine can behind the glove box. Looks like it has all been taken out at some point, I...

Thanks for the tip. I will check on the voltage limiter.