matthon's latest activity
-
matthon replied to the thread Getting stuck in 2nd gear shifting to 3rd.Make sure the gearshift levers are squared off, as well as the holes in the operating levers. They wear each other out. Mine would get... -
matthon replied to the thread 65 belv trans mount?.I needed a trans mount for my 64 318 poly push button. No luck. My 67 bb 4 speed a-body has the same mount except only 1 bolt on the...
-
matthon replied to the thread 1963 Polara bench seat hinge cover.Many pics here: Bench seat hinge covers - 1962
-
matthon replied to the thread rear exterior lower window trim removal?.If it's anything like my 62 there are clips screwed into the body. The clips are in-between the seal/body. Cannot remove clips without...
-
matthon replied to the thread Original Motor Mounts.Run the old as is and see what happens, new stuff is garbage, including poly mounts. Another option, drill a hole through the entire...
-
matthon replied to the thread Shifter issues.Use the KISS principle, check all of the small things mentioned first, including any possible interference of the shift rods at the...
-
matthon replied to the thread Shifter issues.I had the same issue, rebuilt trans, new shifter, everything adjusted correctly. Side cover gearshift lever was the problem. The...
-
matthon replied to the thread 63' Tapered axle 8-3/4 question.I hear the ball & trunnion driveshaft joint is scary, yet it has been in my 64 for decades, many of those with a ripped boot. Never...
-
The gasket you speak of might be the foam gasket. Mine from Cass was gray. The steel gasket goes on first. Using the steel gasket...
-
matthon replied to the thread Axle flange gasket different scenario.I just ordered axles, I find it odd that it does not come with the foam, as the foam usually gets ruined when one pulls the axle.
-
matthon replied to the thread Axle flange gasket different scenario.b/w the housing and brake back plate - black gasket b/w the brake back plate and axle flange - white foam gasket Green bearings have...
-
matthon replied to the thread Taking Up New Residence.Does the inside fold of the interior trim slide or clip over the same bracket that holds the hardboard headliner up? Bracket is at the...
-
-
matthon replied to the thread Anyone else struggle with ACC carpet?.Not the best pic, black carpet doesn't help, but fit my 62 just fine.
-
-
matthon replied to the thread 63' Tapered axle 8-3/4 question.Ditto on my 62, along with 11" drum brake package. Nothing wrong with the 62-63 housing, just swap in new flange axles and they'll also...
-
matthon replied to the thread Anyone else struggle with ACC carpet?.I have ACC carpet in 4 vehicles, fit absolutely perfect in 3. In one, which was vehicle #3, it seemed to fit at first, but soon realized...
