Recent content by Mike Beaudoin

Should be a beast if I can gater the parts, i am an old hot roder and do not buy new stuff unless I have to.

I am trying that route but have not been able to find one yet.

That is interesting, my understanding is that the bellhousing pattern is the same on the SB and the 5.7. I understand from my research that the flywheel is different 8 bolt vs 6 bolt. one guy also stated that he put on on but had to cut 5/8 off the transmission input shaft. Has anyone done this...

I am putting a 2020 5.7 in my 66 Charger, do anyone know how to adapt the A833 to this motor and where to get parts?

No I have two drivers door mirrors one is remote adjust.

It sounds like a bad switch. pull the plug on the back of the switch and jumper the lights if the fues does not blow repace the switch. If it does blow then start chicking bulbd you may a a filment broken and touching ground but it does not blow the fuse until full power is applied. Hope this helps.

I have the long piece for the front fender but not the spear. I think I have a spare w/washer tank, will check. latch pieces I will have to check on, I know I have a full console.

Sorry do not have any

I can not make out from you picture the location that you are talking about but here is pics of a box out of the car.

I have a complete 66 Charger gauge set and dash wiring harness for sale if you want to do the job once.

Sorry it has already been sold.

I believe I do let me check the dash I removed.

Sorry no good rear bumpers, hard to fine around here.

Sorry no trunk springs.

Sorry no spare roofs