Recent content by mnewell337@gmai

71-74 B-Body Trunk Lid Latch Plate & Bolts $25

Yup, got them all connected. Now I just need to figure out of the power window wires in that same area piggy back onto it as well.

SUCCESS! (I know, all caps) Took it one light at a time, and made slow, steady progress. New Phillips bulbs from Amazon worked great in both the dome & trunk receptacles. No filing required, and some dielectric grease allowed them to sink into place. Same with the map light. The Pink &...

One of the bulbs was swapped out with an existing older bulb. Old bulb would seat in the receptacle, new bulb would not. Spring mechanism moved freely, and WD-40 applied to make sure it would do so. The bulb had dielectric grease applied. The new bulb would only lock into place after the bulb...

Tried both, but no luck so far. Time to trace wires!

Thought the same. Used my dremel tool grinding stone to cut the (bulbous) bulb leads down a little. Before and after bulb pic attached. Success. The Console bulbs are now locked into the harness leads. Since this is the first time the harness has been connected, and power applied, can anyone...

Pushed down to the point of worrying about breaking the bulb. Would not twist. Even placed the center console wiring harness bulb receptacle in my bench vise and applied maximum downward force on the bulb while trying to twist it as well. No luck. Going to take a dremel tool to the bulb leads...

Already tried the dielectric grease while first installing them. Then tried WD-40 shot down under the wiring connector face.

I purchased new bulbs for the interior of my Charger and have run into problems trying to install them. I used the attached Bulb Chart for reference, and purchased Sylvania bulbs from my local Autozone. First up was the #1004 Dome Lamp bulb, which had been missing already. No luck getting the...

Lots of upgrades on my 69 Charger. Electronic Ignition kit was one of them.

Yes, I am looking to power the relay for the fans. The Ammeter has already been bypassed, and a Voltmeter added. Power for the fans will come from the battery. Have not had power to the wiring yet, so cannot check, but believe the ignition wire to splice into would be the brown wire on the...

In the process of final connections for all sorts of new wiring in my 69 Charger, and looking for a convenient engine compartment Ignition Hot Wire source to tap into for my dual electric radiator fans. Would a splice into one of the ignition wires to the 4-wire ballast work, or is that a...

I need the black plastic sheath that goes around the outside of the column. Still have it? Mike

Thanks! Don't know why I could not find it again. Mike