• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Recent content by moparfanUSA

  1. moparfanUSA

    SOLD Plymouth Exhaust Tips

    I will be out there on Thursday afternoon.
  2. moparfanUSA

    SOLD Plymouth Exhaust Tips

    Brand new pair of SS Exhaust Tips. I will be bringing them to Carlise $100
  3. moparfanUSA

    FOR SALE 68-70 Plymouth Exhaust Tips $115

    Brand new SS Exhaust tips. These are not the cheap chrome ones that rust out. These are Stainless Steel 2 1/4" ID, $115 Free shipping.
  4. moparfanUSA

    FOR SALE 68-70 Plymouth Exhaust Tips $125

    Brand new SS Exhaust tips. 2 1/4" ID, $125 Free shipping.
  5. moparfanUSA

    FOR SALE 68-70 B-Body Exhaust SS Tips

    still for sale
  6. moparfanUSA

    FOR SALE 68-70 B-Body Exhaust SS Tips

    either one. they are from 68-70
  7. moparfanUSA

    FOR SALE 68-70 B-Body Exhaust SS Tips

    Brand new SS Exhaust tips. 2 1/4" ID, $140 Free shipping.
  8. moparfanUSA

    Plug or cap for A833 trans?

    Just want I needed, thanks much!
  9. moparfanUSA

    Plug or cap for A833 trans?

    good suggestions, thanks
  10. moparfanUSA

    Plug or cap for A833 trans?

    That will not work as the trans end is threaded.
  11. moparfanUSA

    Plug or cap for A833 trans?

    Does anyone know if they make a cap to cover the the speedometer side of the Trans? My Speedo is broken and makes alot of noise. Until I get it taken out I want to disconnect the speedo cable at the trans and cap it.
  12. moparfanUSA

    4 speed clutch issues

    I checked the runout on the bell housing and it was fine. Turned out when I purchased the Trans at Carlisle, I did not check the outer bearing retainer. Turns out that the one on it was for a small block and a bit smaller in diameter than a big block and the tube was cracked about 3/4 of the way...
  13. moparfanUSA

    4 speed clutch issues

    I agree with you Doug, I need to change it anyway to the right one. I am now going to check the runout on the bellhousing.
Back
Top