Recent content by moparnut426

I did actually, and Im not really happy with it, its not labeled front or back, and has a slight forward bow to it, I know its there, but its hard to see unless you know it. And I bought the shitty gel they recommend to use on install, I reverted to my "rapid tach" decal solution Ive used for...

With the intake Im running on the 383 based engine, and using a carb spacer, I needed to cut the base plate to make things work. NOT wanting to cut up a factory shorter 440 base plate, I found a roached out air grabber style base plate cut it to work, and just used an oval filter on it...

They called Dad "putt" because he never drove slow, So Im putting "4 PUTT" on the plate, No only for Dad, but I SUCK at golf... Fitting! Im on the Alumni committee in my small town, and this year is Dads 50 year class reunion, Done or Not, its gonna be on a trailer in the Parade!

Lot of Pics in my phone,,, WOW

Last couple for the day lol

Appreciate that man! Factory color, B7 Jamaica Blue

Sorry for the photo BOMB, but am getting quite excited for the finished project!... Had a guy in Arizona do me up a fender tag for the car, Afrer I signed off I realized that I screwed up the paint code, as a 70 code... Second tag is Dads favorite slogan he coined himself in Sturgis! LOL...

I Built it into a N 96 car, and as a Vinyl top car, but other than that its the same car, well not really, but close enough for me...

Hoping to get it on the road this summer, I bought the car in 16, Dads actual car is about 1/2 hr drive south east of me and is sitting in the trees where its sat since 80. Wont sell... so I did the next best thing, I actually found a real Bee the same color, I just added Dads options.

Few More... Building to Match this car, My Dad vintage 75 senior pic. Miss his every second.

I dont post on here very much, but I thought Id post up some progress pics of my Bee. Mind you Im doing 99% of this my self in my little shop. Engine is a 434 I built out of some good used parts I had laying around, a 440 crank that was cut too far to be used in a 440, etc etc,, Source heads...

Im currently in the same boat on my Bee, On the pop out windows, I plan on using 3M 1/4" butel roll squished up under the lip, then force the frame against the lip as tight as I can. Mine currently fit "ok" Ive only got the drivers side in, but I plan on removing them and wedging that butel...

Whats the small pin size? Im not on here much so can ya email me at [email protected]?? Thanks Kasey