Recent content by mrrandyj

I have 3 intake / exhaust manifold assemblies from slant 6 engines. $50 each. I'm going to Carlisle and can bring them with me if there is a buyer.

Thank you, I'll keep that in mind if I don't find anything at Carlisle.

Thanks for checking. Are you going to Carlisle?

Thanks for the replies! If I can't find anything at Carlisle I will reach out.

I would like to meet and pick up at Carlisle..... Looking for a nice original hood lip molding for a 1966 Coronet, not a reproduction. Thanks

Brand new US Cartool mini tub kit for 1966-70 B-bodies. The part number is USCTAM2010. Still in the original box with all paperwork and templates. This kit is $419 new from US Cartool. I can deliver it to you at Chrysler's at Carlisle, or it can be picked up in Connecticut. $325 obo

Edit: I believe I have a nice drivers side being delivered to Carlisle, still looking for the passenger side. I would like to meet and pickup at Carlisle...... I'm looking for a nice pair of clear glass rear quarter windows and frames for a 66 Coronet 2 door hardtop. The numbers cast into the...

Sorry about that, I just cleared it out and sent you a message.

Reproduction rear bumper reinforcement plates for 1966-1967 Dodge and Plymouth B Bodies. Fits Coronet, Charger, Satellite, Belvedere, and GTX. These are welded onto the rear crossmember where the rear bumper brackets bolt up. Made in the USA from the same gauge steel as the factory plates, and...

I am looking for a nice passenger side lower control arm with the sway bar tab for a 68 b-body. I would buy a pair if necessary. Thanks! mrrandyj@aol.com

I make the rear tie-down brackets that bolt on to the existing u-bolts, you just need to have enough extra thread hanging down to fit my bracket and another nut. They are $70 including shipping anywhere in the United States. Feel free to email me with any questions mrrandyj@aol.com

70 Coronet R/T or Coronet 500 finish panel. This is in fair condition, it will need some work. There is damage around the hole for the truck lock, as well as some damage in a couple areas on the outer edge. All the DODGE letters are there, as well as the R/T emblem. No shipping. I can deliver it...

NOS 1973-74 drivers side big block HP exhaust manifold for a 400 or 440 B-body. The casting number is 3751068 with a 2-20-73 casting date. This manifold is brand new, it has never been bolted to an engine. $300 obo. No shipping, pickup in central CT, or I can deliver it to Chryslers at Carlisle.

Passenger side fender from a 1970 Dodge Coronet. Has a little rust through at the bottom and also a little damage from someone using a torch to cut off the front valance bolts. These are hard to find and are not reproduced. Can also be used to make a Plymouth Superbird fender. No shipping. I can...

Trunk lid for a 1967 Coronet. It is in better condition than most out there. A little pitting on the rear inner lip, but no rust through at all, still has its original paint. No shipping. I can deliver it to Chrysler's at Carlisle or you can pick it up in central Connecticut $450 obo