• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

muscle72's latest activity

  • muscle72
    muscle72 reacted to Vaanth's post in the thread Mallory distributor with
    Like
    .
    The post about the wiring of the Mallory Unilite distributor for replacing a stock contact point distributor was a clarification of...
  • muscle72
    muscle72 replied to the thread Mallory distributor.
    Thanks for info about resistors,what l though you could use stock resistor
  • muscle72
    muscle72 replied to the thread Mallory distributor.
    If you couldn't use a stock ballast resistor,it would state in the instructions on what ballast resistor to use.Obviously you can use...
  • muscle72
    muscle72 replied to the thread Mallory distributor.
    Shut your mouth your knowledge is useless and you can use the stock ballast resistor bye troll keyword warrior
  • muscle72
    muscle72 reacted to Vaanth's post in the thread Mallory distributor with
    Like
    .
    The Mallory Unilite instructions listed show the wiring arrangement and details, but for more specificity to wire the Mallory Unilite...
  • muscle72
    muscle72 replied to the thread Mallory distributor.
    Thanks for the detailed info where each wire connects to.you answered my question with red wire.so it connects to blue wire from engine...
  • muscle72
    muscle72 replied to the thread Mallory distributor.
    Here's the instructions
  • muscle72
    muscle72 replied to the thread Mallory distributor.
    Mallory is a 3 wire distributor
  • muscle72
    muscle72 replied to the thread Mallory distributor.
    What side is the 12 volt side on a 2 prong ballast resistor?
  • muscle72
    muscle72 replied to the thread Mallory distributor.
    Reading the instructions is easy to set up,what is loom resistance wire if run the positive side off coil
  • muscle72
    muscle72 replied to the thread Mallory distributor.
    Have any pics on how they wired up the mallory distributor?Says need you have to loom resistance wire positive side of coil.Whats loom...
  • muscle72
    muscle72 replied to the thread Mallory distributor.
    You can use regular factory spark plug wires and any coil.mallory unlite is the same as mallory magnetic breakerless
  • muscle72
    muscle72 replied to the thread Mallory distributor.
    I got it fairly reasonable
  • muscle72
    muscle72 replied to the thread Mallory distributor.
    This mallory is electronic distributor not points
  • muscle72
    muscle72 replied to the thread Mallory distributor.
    Mallory is old school and hear there good distributors
Show older items
Back
Top