Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hey John, I think if you could get your PSI to 6 - 7lbs your post shut down flooding may stop. With multi-carb street set ups volume under load is more important than pressure. A good high volume mechanical pump with a 3/8"fuel line should feed your 2 Carters fine. Just my opinion.
Running a Clay Smith Mechanical on my 440 XRam with (2) 750cfm Eddys, 3/8"lines, no external regulator, 7psi and it works great. No fuel starvation at 6200rpm. No vapor lock. Keep things simple.
Do not put those 3/4"plugs in a big block. They are for a small block appl. In Champion numbers you want a shorter "J" number plug for big blocks. The 3/4"plugs are an "N" number. I run J14Y Champion plugs in my 68 440. What heat range you run can vary depending on the engine build. If stock...
If you have drum brakes on any axle you have to have a residual check valve in the MC port or an external aftermarket one in the line just outside the port or you will have a lazy/low pedal. The drum type wheel cyls do not have check valves internally or do they compensate as they have to have a...
Your front MC port(farthermost from the firewall) feeds the rear drum brakes and needs the residual check valve in it, not the rear port that feeds the front disc brakes. You will have a very low pedal with it in the rear MC port.
You could order them with radio and heaters. All were not post cars either. You could order the MW package on any one of the BBody Plymouth or Dodge models.
Correct R413, 3447s were used on 62 413MWs and 63 Stage 2 426s. (There was no Stage 1 designation used). 64 426 MWs were all Stage 3s using 3705s. This Dodge does have many of the MW parts and arrangements specific to the originals. Would need to check the VIN# with Darrell Davis or his 63 Dodge...
Spray it liberally inside with carb cleaner and let it soak upside down 15 minutes. Then flush it with brake clean and dry with compressed air. I've done several old ones that way and never had the fiber come out. Wire wheel the outside and paint the outside gloss black and your done.
The factory did do a hack job when cutting out for the shifter hump on these B bodies. Literally looks like a 5 year old did it. Standard practice on 62-65 B bodies with manual floor shifter.