Recent content by patbclc

Thank you I'm not really setup to go in from bottom but will keep it in mind

Did you use tremec 5speed and drop in from top as a unit?

Thank you very much I appreciate it!

Any advice from anyone I'm going to install a 472 Indy aluminum hemi with tti headers and tremec 5 speed in my 1970 Charger RT 440 k member with 4speed in spring. I really am hoping to put it in from top as a unit. Thank you in advance.

Hi, I'm looking for 4 of these small headliner bow clips for a 1970 Charger. Please let me know if you can help

No wasn't broken. It came loose though. I backed out more for picture. Pushrods too short and rocker tip had to be adjusted out to far. Gonna get measuring adjustable pushrod tool and have proper length pushrods made to fit.

Yes I agree, going to order an adjustable pushrod tool. Thank you I appreciate the help everyone

Thank you

Thank you

Thank you

Thank you

Thank you

Yes I took off and measured pushrods. About 8.25 tip to tip and .175 recess in cup. I had 4-6 threads showing below rocker arms. Isn't 1-2 normal? I figure 4/24 = .166 longer for pushrods? They are 3/8 with 5/16 ball. Are the measured tip to tip or tip to cup recess? Really appreciate the help...

Thank you so much, cup is a little screwy and worn on top. I agree push rods seem short and not full thread engagement? I'm gonna measure tomorrow. What would you recommend for push rods? Stroker 452 (400 block) edlebrock heads. Competition cam, 2 inch headers, M1 intake etc.

Hi I'm looking for help identifying these rocker arms and push rods. I built motor over 20 years ago and forgot brand ad need to get at least a new push rod. It's in a stroker 400 block Thank you in advance