Recent content by pooner

Yepp, it measured 3.222"

Yes it is most audible on the pump casing, so the idea is right, but, maybe something else there close by thata slamming, maybe timing chain trnsioner or so?

Hi, yeah what is FSM? This my first Mopar, i am a Ford guy otherwise :) what color plastigauge should i get? I guess the easiest while pan is off is to pull the main bearings and replace them while engine in car? Tested today, couldnt get one bolt to move in the tightening direction, its only...

Yepp hope so too, ordered a new one, Spectra pump, hope they are good. Will do some timing checks also.

Update: Just had some minutes with the car today and played doctor with the scope, i can hear the noise clearest when touching the fuel pump housing so guessing its time for a new one. I also suspect i have weird timing so will check later on, ordered some new cables and dist cap+rotor because...

Will do once i get it up in the air, or is it easy doable from the driveway maybe? i guess there are 4 bolts to check that holds it to the flexplate?

HI, about 10-15 psi at hot idle.

Could be, going to check the PS pump soon, it was low on atf... 10-12psi hot idle is little low i think also, if i for example hot idle and put in drive the oil pressure light will start flimmering little bit, but would a collapsed lifter lower the pressure so much? Its 20w50 in it now, maybe i...

Also tried today and disconnected one spark plug after the other while running to see if the noise dissapears but no luck there.

Hi, tried it but no difference, knock is barely noticeable when revving

WOW! What a response from the community! :) Appreciate all your inputs, made a short video this morning coming home after leaving one of the boys at school. Sounds like coming from front/middle of engine. The crank pulley seems to wobble but can also be hallucination... Yes i will fix the...

Hi, first post here and first older Mopar :) I have a noise, a ticking/knocking noise when i drive, specially during cruise at around 30-50mph. What could this be? I have enough oil in it, 20w50. Sounds harder in the video than in real life, but it resembles that of a lifter problem. Quiet when...