Recent content by pturner

Just wondering if anyone has been to the Moparfest at the Battleship at Mobile, AL. Show is on April 26-27. It is a long way to travel for me, but I would go if it is a good show. Any opinions, suggestions or additional information including lodging is appreciated. PT in Tennessee 1968...

Finished a new shop with 12' ceiling, now ready to buy two post lift. How did you deal with the shipping? Can you get them delivered to a freight terminal and then pick it up there? Delivery to my residence could happen, but I would have to rent a fork lift to unload it. Will the freight...

I am taking my Roadrunner to this show next weekend. Just today saw some info that you could not put up a canopy unless you did it in the grass. There doesnt seem to be much grass. The picture shows most of the vehicles in an open parking lot. Weather is supposed to continue to be hot and humid...

Both shots made me feel like crap the day after each. Almost like the flu. I had the One shot years ago. My doctor advised me to do the Zostervax 2 shot again. He said the 2 shot was over 90% effectiveness. My wife had both shots the same time I did, but never felt very bad. PT in Tennessee

I would like togo, so does anyone know much about this show? like to have a conversation with some one. Thanks PT in Tennessee

I am going. already sent in registration. PT in Tennessee

just saw this posting. it the road that was closed a road i will travel to the Saturday show? I am coming up 74 from ashville, but i know i have to get on the Interstate thru Gastonia, and then get back on 74 to get to Rockingham. thanks Pat T I was going to send you a PM, but the system says i...

thanks for the kind comments. Your Roadrunner is something to see also. Pat

I went last year. Weather was predicted to be bad but really was fine. Some of the show organizers said turnout was a little low. BUT, the people there were some of the friendlist and most down to earth folks i have been at any show with. My Roadrunner has showed at virtually every major Mopar...

Ordered a few stainless fittings today. Have them tomorrow. Again manyThanks for your help. PT in Tennessee

Working to correct hose configuration this morning. After removing my sending unit in the front hole I see it is a 3/8 NPTF hole. I can use a bell reducer with nipple to make it fit my 1/2" NPTM oring hose fitting. Your pic looks like 3/8" also. Just wondering why 3/8 ? I guess flow thru a 3/8...

Thanks all for the good info. The pic supplied by pnora is exactly what i have. I do not have the ports connected this way. Yes, the housing is from PRW. That was supplied by March with the other components for the belt system. I have one sensor for a dash temperature display, and the one on the...

I do have one but the factory stock pump has ports beside each other running front to back, my PRW pump has the ports left side to right side.

I had asked this question about one year ago. I cannot get water flow thru my heater core. I am using a March Revolver system and it utilizes a PRW aluminum water pump. The water pump has two 3/4" NPT ports on the pump. One is close to the thermostst hole and one is furthur away. I cannot find...