Recent content by pwm72

LOL...I need this!

Welcome...also from MD...

Welcome from Maryland, I am another 1967 Coronet convertible owner.

So a few weeks ago I asked about the type of nuts that attached the console lid to the hinge. I was able to purchase the correct nuts but they don’t seem to tighten very well. As a result the lid doesn’t seem to fit correctly. Any tricks to this? I can push down on the lid when it is closed...

I will take it. My cell is 302 437-6172. Send me your paypal address or venmo (however you want to be paid). My name is Paul Manuel Thank you

Would you consider $125 shipped? (zip is 21921)

I stepped away and upon coming back, figured it out. It is just a pin that you drive through.

I am replacing my convertible top cylinders on my 67 Coronet. I removed the “mounting plate” and pulled the little pin that retains the ram to the top mechanism, but what is the trick to removing that ram eyelet from the pin? It does not feel like a nut on the back and the “pin” just seems to...

thank you for the detailed pics!

thank you!

Thank you, but I am looking for a pictures of them installed. Apologies if that wasn't clear.

perfect, thank you!

These are like hens teeth to find in decent shape! Good job reproducing them.

As you may be able to tell from the multiple requests, I am putting the interior in my 67 convertible. Would anyone have close up pictures of where the rear interior panels attach? I am hoping to get detailed pictures on screw placement along the top as well as at the bottom where it meets the...

Would anyone have a picture of the hardware used to attach the console lid to the hinge? My car was in pieces and I can't see to find what kind of nuts are used as the studs on the lid itself don't seem to be threaded in the traditional way. I would appreciate it.