R413's latest activity
-
RThey're brinneled.. and for the cost of them, I've never heard of someone reusing them. And you will not break a 7290 with a 383...
-
RR413 replied to the thread 69 Bee, 11” Drums - Auto Adusters or Not.You,can do a lot of driving before they need adjusted again. Manual adjust is way simple and no problems of brakes too tight as many...
-
RR413 replied to the thread On to the NEXT issue…..You can't take the last owners word on how much gas is in the tank. the gauge may work just fine. 2 options to know for sure. 1) Fill...
-
RR413 replied to the thread Part Identity.1970 b-body standard dash switch panel. Both Dodge and Plymouths, non A/C.
-
RR413 replied to the thread Rear differential drain plug.Get a quality crescent wrench that the moving jaw stays square to the top and they won't round off things. They sell 8 point sockets...
-
RR413 replied to the thread Beat up flywheel?.The ring gear is more than fine, it is in great shape.
-
R408 is the code for sure grip. The code for dana 60 is 406. On your fender tag under AX the code will be 68 for a dana 60.
-
RR413 replied to the thread Beat up flywheel?.What bellhousing do you have? Stock one or a scattershield? Sounds like a starter problem, where are you getting these starters...
-
RR413 replied to the thread Suggestions for stock clutch.I understand, but what's not working is the muscles and joints around the knee, not the new knee. Many joint replacements don't work...
-
RR413 replied to the thread Need Dash to Windshield Measurment.Lay it on there? That's a hope and pray method without a gasket. tThe gasket holds glass in place off the metal frame. how will you...
-
RR413 replied to the thread Check your fuel lines.When buying rubber fuel hose get the barricade hose from gates. It will stand up to modern ethanol fuels. The regular hose will crack...
-
-
RR413 replied to the thread Suggestions for stock clutch.The fact that you have new knees is great because the joints should work great now. So why why the statement "they don't work as good...
-
RR413 replied to the thread Mystery Wire.That harness would be attached to the old dash wire harness. Plugs into,the blower switch and then goes to the blower resistor on the box.
-
RI appreciate the wealth of suggestions. First- presently every thing is new, including the underside of the car. There is no dirt...
-
RR413 replied to the thread Mystery Wire.Does it go the the heater harness? This is why there is no plastic connector, it goes in the heater switch plug. Usually the heater...
-
