Recent content by rgp266

Took a look at Hamtramck-historical and found just about everything but what I needed. Thanks for your replies.

Thank You, Sir!!

If I had the clock and/or the fasteners that would be great but........I don't. What I need is thread pitch and count plus fastener length. I can tell you that the holes for the fasteners are 3/16". Thanks Bob

Converting a Clock Rallye dash to a Tach. dash on my '73 RR. Any one know what size fasteners I need? The pedestals are there for the fasteners but need to be opened up and the threads tapped. T hanks Bob

I have a 73 RR that I have been plugging away at for too many years. The interior is a low option color which I am having the devils own time finding replacement fabrics/vinyl for. Carpet is Y-7. What is it called? The interior trim code is C-2 and Y-4. Again, what it is called? I know it...

The ones I used were big block only, I do not know of a small block application....... Bob

Mopar Performance used to make a special grooved rear main bearing that routed the oil to the crank side of the main for better drain back. I have used them on several builds and never had a rear main seal leak. Bob

I need the Pot Metal instrument cluster housing for a 71-74 B body with Rallye cluster. Must be from a Tach. or Clock dash, standard Rallye parts won't work. Thanks Bob

Thanks, Glenwood. His car looks a lot like the one in your photo.

What I am looking for is a patch or repair panel for the right front fender front lower section to include the wheel well opening. My neighbor picked up a '64 dodge rag top that had been sitting in a garage since 1971. The only significant body damage is to the RF fender where it hit a stump...

Anybody making them any more? Used to get them through Sherman and associates but have not heard of them in years. Bob

Thought so. I bought front and rear lower Valances from you for my '73 RR. The assembly in the upper right photo is what I need although I do not need the actual instruments. Make me an offer I can't refuse. Bob

72blue.........top right photo is just what I need but without the gauges. If you are near Dorr then I bought some sheet metal off you a few years ago. Bob

Looking for the following.......part number (s) are pulled off of the parts needed. Not sure how to describe them. 2985184 2985238 White plastic "bezel"? This has the clear plastic instrument covers in it. 2985172 Die-Cast/Cast Aluminum housing for the cluster. Also had the numbers 301035-1...

I need the A/C vent piece from Center dashboard to the passenger corner. the one with 3 ducts in it and charger SE trim. I have no clue to what it is called. Bob