Recent content by sixtiesmuscle

getting the 65 running again with a new radiator, Hoses, custom made lower to get the hose from drivers to passenger side on New Aluminum Radiator. New late model small block outlet will be on the passenger side. This 273 motor is still coming out... I just need to be able to move the car...

well, "They" do make aftermarket brackets for the Federal pump and the early Saginaw for use with the later water pump with no ears.....The factory didn't make those..... I just don't know why they don't for the TRW, unless its just not compatible with a rear style bracket....the difference is...

I'm considering that, just seeing if there were any already being made....

I thought of that as well, but while sourcing parts already for this conversion to the later engine, I already bought an aluminum radiator with the outlet matching the later model pump....

Gentlemen, I have seen Brackets for Saginaws, Federals, etc to mount these pumps to the later model aluminum water pumps without the cast Iron style ears. But I cant find anything to mount a TRW ?? I'm putting in a later model (75) LA motor which has the Aluminum Water pump with outlet on...

Merry Christmas to you too Dave !!... and to everyone on the site !!!

BEAUTIFUL !! I LOOOVE a Satellite !!

Wow !!! Yep Thats exactly what I have !!! Beautiful car !! I'm working on getting my engine bay that clean now !!

Slowly working on the 65....Ordered everything I need to switch out the 273 for the little 318 I bought.... Been Cleaning and Polishing ALL the trim, Bumpers,etc. Cleaned the interior, Bought Floormats. Slowly "working" the light rust areas with CLR, and elbow grease, and then Polishing and...

Picked up a Rebuilt engine today from a Diehard Mopar man.... He's an Engine builder. This was his engine he just freshly built 322 CI Small block for his Demo Derby Car. He ran it about 5 mins, and a piece of metal came through the floor went through his calf... He almost Bled out. 12 Hours in...

Got Magnum 500’s on the 65, We got her running and charging…. Driving her around now… best thing for a car that Sat a bit… We did Carb rebuild, Points, Plugs, Cap, Rotor button , Coil, Fuel Pump, fresh Gas, Oil and filter change. Replaced a lifter, new Alternator, Voltage regulator, Battery, &...

Not right now..... Getting it running, etc etc. going through the basic motor stuff, New Fuel pump, rebuilt carb, Plugs, wires , Coil,Dist cap, points, rotor button, Oil & filter change.... Fired it up yesterday, It runs, Guages work, heater controls work, goes in forward and reverse Gear...it...

That's Funny !! That's EXACTLY what I have in my 64 !! 440 dressed out as a street wedge.... Same broom Handle cam too !!

From the looks of his front Tag...... His is bigger than mine.....Story of my life...

I did, I contacted him very shortly after it appeared and Said " I'll take it "... Then We talked, about the Cars History, and I knew I wanted it ( short of getting there, and it was a rust bucket ). I asked if he had a CASH price he wanted to be at ? Sometimes folks Say "full Price", Some Say "...