Recent content by Ski 61701

Another thing you might want to check is your oil level in case the diaphragm is starting to let go and leak into the engine. Usually they leak via the external weep hole on the pump but just something to check since you are checking things out. Hopefully it's just an old hose by the tank that...

If you can get a hold of a FSM for 1964, the transmission section spells it out on how to adjust both the gear selector cable and the parking cable. If you drop the pan and have a helper run it through the gears you'll be able to get it set just right and you won't have to worry if you got it...

What I think you will need to do is look at Dorman products. They make aftermarket parts and here in the US they have all sorts of plastic clips for moldings. My guess is that you will have to measure your holes in the A pillar and try and find a clip that you can file down to fit the trim...

What radiator are you using a small block or big block rad? The small block rad has the hose in the middle of the top tan, the big block has the upper hose on the passenger side of the rad (top) It is kind of hard to see if there is an indentation (slight curve of a cutout on the top half of...

https://www.hughesengines.com/Upload/TechArticles/INTAKE_MANIFOLD_SEALING_DECEMBER_2021.pdf This is a good article to read

http://www.superformanceproducts.com/catalog/2016SuperformanceCatalog_RacerNet.pdf Not sure on your port size but there are a few options here and the gaskets are quality in my opinion. If you are going to use any sealer on the gasket, use a non-hardening permatex on the valley pan side. Im...

I'd say that the intake to cylinder head angle is off and therefore oil is starting to get sucked past the gaskets. There is a way to check to see doing a dry fit of the intake minus gaskets and seeing how much clearance you have. I dont remember the exact procedure but its not hard. Hughes...

Special T is NOT cheap. I brought him a few pieces that were already stripped, straightened and polished out all they needed was to be bright dipped. I paid for it big time, meaning that I paid for straightening and polishing on top of the bright dip. Bill is a nice guy, but the next time I...

Can you swap the tires back to front ? I wonder if you might have a belt starting to separate or something of that nature with the tire?

I'd definitely would crawl under the car and look at the transmission and see if whomever swapped from the 361 to the 318 left the oem cables in place. Ive heard of guys putting an aftermarket shifter in the console so they have the oem interior look. Hopefully this is the case for you it will...

What kind of shifter do you currently have in the car? Is it the column shift with the selector cable and park cable? Or did the previous owner put in an aftermarket floor shifter? If that is the case, then the transmission year is kind of moot point, other than possibly the rear mount. You...

Im running the Carter M6903 pump and not having any problems with fuel delivery. Its around 5psi

I have a B block cast iron dual point distributor #24444360. The shaft spins freely and there is no wobble. Missing the vacuum advance canister. I can bring to the Indy swap meet in March. $75.00

I have a RB Steel crank that is STD on both rods and mains. I just had it magged this past weekend and it passed. Machinist says that it will polish up at std no problem. There are a couple of little pits on a couple of the journals that he said would clean up at .010 I can bring to the swap...

Mailbox is now empty, thank you Photon 440