Recent content by Street fighter

I believed that also but once I pulled the trans I found it to be ok so I replaced the stall with a b&m 10416 that have a stall of 2000 along with the flex plate needed to balance the engine. The car ran grate before the new stall install great response. but now it seems to need more paddle to...

I have a tci 141503 convertor in my 73 360 charger that I believe have gone bad,I can head it knocking when idling.It is no longer sold so I want to know what is the stall speed on it and is the tci 141500 the same but need the flex plate to balance the engine. small Edbrock 280-280 cam.

I have a 73 dodge charger that runs good looks good, but the steering is bad, I replaced the steering gear that was leaking, that helped some, but the car is nothing like any of my other cars, for one the car is a big car and I have to keep my mind on this car because it just seems to drift on...

I might have gotten carried away about the 1/4 but there is 1/8 I am sure of. I replayed the bushing a while back but I had to pull the trans to get it out hard job. I had a new drive shaft made some years ago, because the guy at the shop told me that the shaft that I had in the car were known...

The u-joints are good no play in them it's in the yoke. where it goes on the shaft of the trans I can raise it up and down I would say close to a quarter of a inch. I checked the end play of the yoke on some of my other cars and there is almost none. which make me think my problem is in the...

I took a break from the charger problem and rested my nerves. I got under the charger and checked front and rear u joints for the countless time., I noticed that the front yoke has a good amount of up and down play in it, just how much play should be in the shaft up and down? The yoke and...

on the 360 I have which came out of a 80 dodge car the converter has two weights on it one on each side of the drain plug of the converter. and the flex plate is stock I checked my papers that I keep on everything I put on the car and it showed that I got the converter nine years ago. I don't...

I have removed all the fan belts and still gets the vibration which is why I believe it's in the converter I hate spending money on a guess, I don't have much of a choice if it's in the converter the only way to know is to install a new one and pray that's it.I have replaced so much under the...

I have had the car for thirty years everything under the car but the headers is new and I plan to replace them after Christmas as a gift to myself. the engine was rebuilt about ten years ago and have about 4000 miles on it if that. the 360 have been in it with no problems since rebuild.

The trans have two weights on the front of the converter I have tried to correct this issue for a year or more, I drive it get pissed and park it,the car looks great a eye catcher and gets a lot of nice car, but I don't want to keep driving it knowing it has this problem, I need to get this car...

I was thinking about checking the Dampener because it has been on this engine since 1980. the noise I hear is like it's out of balance when you stand in front of the car makes a bumping noise.

more like clicking, stall is 2000-2400 all is done with converter loose from engine. how do you do a stall test?