tonysrt's latest activity
-
Ttonysrt replied to the thread Rear end noise 8.75 .. 741.I have a 489 that was making noise and the gears were bad. Replaced gears and no more whining. Certain gear ratios are getting rare with...
-
Ttonysrt replied to the thread Which wiper motor on 68 hemi GTX?.I have a 71 Cuda with the 3 speed wiper motor. Using the 2 speed motor comes straight out of the fire wall and limits space with a Hemi...
-
Ttonysrt replied to the thread e body k frame question?.I have a 71 Cuda and there not on my K frame. Car was originally 383, 4 speed. I went to a Gen 2 Hemi K frame and not on there either.
-
Ttonysrt replied to the thread Oil pan plug washers..Try teflon tape on the threads of the plug.
-
Ttonysrt replied to the thread Let's talk more about garage door openers..I have 3 Chamberlain openers from 06 -10 purchased and have been flawless. When I first moved in 40 years ago I bought a Stanley opener...
-
Ttonysrt replied to the thread WOT issue 2bbl 318.I looked on Rockauto and the silent timing chain with the plastic gears is cheaper than with metal gears
-
Ttonysrt replied to the thread WOT issue 2bbl 318.I found it hard to believe they would use anything more expensive to make to install. Just look at the long list of recalls and it was...
-
Ttonysrt replied to the thread WOT issue 2bbl 318.You may have a cam problem, they were using plastic gears to save money and screw customers. I had a 318 with a new timing chain, but...
-
Ttonysrt replied to the thread SOLD Mopar 318ci/poly cam shaft & lifters NEW $300 FREE shipping.Heading says 318 cam.
-
Ttonysrt replied to the thread Sanity check for charging system.Might have been the regulator all along and not the alternator.
-
Ttonysrt replied to the thread Sanity check for charging system.Since you didn't say anything about the regulator that also has a lot to do with limiting voltage, did you replace it? Voltage should be...
-
Ttonysrt replied to the thread Pre-Oil or Not to Pre-Oil.Removing Distributor, mark hold down with a sharpie marker and Distributor and pull off plug wire where rotor sits.
-
Ttonysrt replied to the thread Cost for reupholstery.Those seats look pretty straight forward. Some bucket seats are more intricate where they need wires inserted for different lines in the...
-
Ttonysrt replied to the thread Bucket seat mounting dimensions.When I did this on a 74 Duster the bench seat hole didn't line up with the 4 recessed dimples for the bucket track.
