Recent content by Trench

UPDATE SOLUTION FOUND: Thanks for all the helpful posts! With them and talking to CVF Racing I purchased a replacement PS pump with the hose relocated to the side of the reservoir and this fit. I still have to get a longer low pressure hose as it is now a bit longer than before but this is...

Thanks, very helpful.

The brackets look the same as the factory ones but my pump is different. I'll try to get a better picture in the morning but it looks more like the Saginaw P Series Power Steering Pump

Yes

Chrysler Big Block Power Steering Bracket (383, 400, 426 & 440)

Thanks for the feedback pnora, it's much appreciated. The brackets are from CVF. I changed to a newer style AC from them and changed the PS bracket at the same time. They do have a PS pump as well and I do see it have the hose routed around the bottom of the pump as opposed to behind like on my...

The hose does not fit between the bracket and the head. Is this the correct PS pump? If not, what one should I have? Thoughts? As always, thanks everyone. :)

I contacted Firm Feel ([email protected]) and they were very helpful and able to get me a set for my 73 Roadrunner. They were $40

Wishing all of you the very best this holiday season!

I'm with the majority here and would not pull the k frame if it is already in the car. With the help of a come-along I managed to install from the top by myself but it is way easier with 1 or 2 helpers.

Will the original receiver/dryer work with the Sanden compressor?

There is another tab with the last 6 numbers of the VIN number stamped on it. It is just above the oil pan.

Thanks!

Thanks, I think this is what I will do. Can you share where you got your upgrade parts?

When I had my 440 motor rebuild the water pump put on was with the exit on the drivers side. I have got everything to fit except the AC compressor, it hits the water pump thermostat housing. Anyone have a solution for this? I would like to keep the AC if I can. I am wondering if the brackets...