Recent content by velocityss1985

Absolutely, if not the gear oil will wash out the grease of the sealed green bearing.

I'll have to look and see what dates I have.

Let me check I may have the splash shield. I know I have the hood latch radiator support if needed as well.

Yes, Dr. Diff sells the inner bearing spacer. For the later rotors to be used on the early spindles.

Welcome from Western NY! Nice cars!

I would be interested in this as well. Following...

Dam! I'm looking for 0A136175. Thanks for reaching out

Those are inspector's stamps. Common

Mopar A Body 67-72 & B Body 68-70 Door Glass Division Channel Guide Set 2932230 DMT has the curved ones

1969 Plymouth Other Roadrunner | eBay Show him this... 69 Hemi B5, granted it's a RR not a Bee, but comparable.

Is that the factory board? I thought they were on cardboard.

Yes, they should come with a thrust button, but if you get it from some random supplier or used it may not. Not a big deal to install one either. The 3rd member doesn't have to come apart. Yes, with the green bearings I would remove the thrust button, because there is a chance of extra side load...

There are no seals for the axle bearings just a gasket for the 5-bolt flange. There are on the other hand "inner" axle seals that are very easy to change, they go inside the housing ends. No need to press axle bearings on or off. It is really an easy operation to change out the 3rd member...

This just popped up. Facebook

ok thanks. Yeah the stuff I need is gone then.