Recent content by zippy

Mopar Collector prints Dodges Plymouths Challengers, Cudas, GTXs, Road Runners, Hemi. . ... all 54 different Mopar art prints. Original Lithographs produced by Chrysler in the early nineties. Printed on high quality heavy weight paper. 11" x 14" Fours sets included for 35$. . .everything...

Hello everybody, does anyone have an original 1968 GTX finish panel. I have to paint one for a restoration soon. Is it dark argent gray and is there any light argent on it. Visable cut lines would be great...Is the light argent for the sport satellite?Thanks Kevin

Any bod y know how to remove a 1970 440 GTX intermediate shaft. It wants to move an 1/8 inch but can't get it out. Do I need a tool. Old one was sheared off and replaced oil pump....cant get the shaft out...any tricks please thanks

Can any body confirm I can start my 1970 GTX with the turn signal indicator switch un plugged. I need to move my car and the turn signal switch melted. So id like to rule out a couple of things and that is the first since she won't fire up since the melt down...Thanks

Here is a link to a 1970 plymouth manual. I can take a picture of the original manual I have but I dont think the resolution would be so good and I dont have a scanner available. If you dont mind following this link and scroll down to 1970 plymouth manual. Then scroll to section 8-146 its listed...

I need an electrical master,too bad you aint in michigan Id cook you some grub. Are you sure car should still fire up with the turn signal indicator unplugged. The key light wasnt hooked up it is a separate wire I left unhooked.Also interior lights and door switches worked fine before melt down...

Hello, and thanks for all replies. I have a 70 GTX and the turn signal indicator switch had a melt down. Actually caught fire and smoked out. I replaced it with a used unit from ebay. (bad move I believe) After I installed it in the car it is now blowing the fuse for the interior lights which...

Gtx trade Yes you are right Z pops....I just really always liked the chargers a little better. If I keep the GTX I will still be in big block survivor bliss.....car is clean and ready for dream cruise burn outs

1970 gtx trade for charger? do you have interior charger pics.Thanks Kevin

I just completed the gig...lots of hammering and penetrating lube...even with specific tools I had to have the local garage handle a couple of bushings(pressing in and two removal. On the ground with out a lift sucks but just some good news all that crap goes on a lot faster then taking it...

Did not remove them as sides go...i finally got them in by tightening up the front of the strut nut to pull it forward as they were back from new rubber bushings....thanks all...great advice

Hello, dig the help so far,,,any body? I removed the torsion bars for PST front end rebuild kit. Problem is I did not document the location of the markings on the back side or the rear end of the torsion bar. They have numbers and some letters with a centerline running through it. I never...

Awsome brother Baller....Thanks

Gtx emblem placement I would appreciate it. I have not seen any remotes any where but on the woodgrain/ chrome trim piece. Id like to put it there, but want to make sure its in the right spot. There are no holes in either but the door cards could be new as they are in great like new...