Separate names with a comma.
power is more limited to head/air flow and how hard you want to spin the engine. Less CID, just need to spin it more than a larger CID engine....
They are pretty easy. The seals are sized for different diameter wires, and the pins/plugs also come in different sizes for wire gauge....
I use the ARP bolts and studs. I don't know who supplies the 440 source bolts? Maybe they will chime in. Had problems with some "grade 8"...
Copper coat
If the heads don't support the airflow at the higher lifts, the ports might flow less (at the higher lifts), and your spending more power just to...
Depends on your build. Really need the duration specs. Is this cam around 280 duration @ 0.050"? I think you might run into piston-to-valve...
The '71 Charger has a 20-gallon aluminum fuel cell/tank with foam. It is pretty basic tank/cell, not one of the Fuel safes that are designed to...
The class you are racing in will determine how much of a disadvantage you might have. It might be difficult to compete with transbrake cars, but...
https://www.holley.com/products/fuel_systems/fuel_injection/sniper_efi/sniper_stealth_4500/parts/550-842
my 500" stroker is sort of like that, a bit more compression and cam. I am using my old Indy 400-2 (4150) single plane intake, and have used the...
I has aluminum fuel line that cracked at the fitting after a few years. The stainless lines are nice, but more difficult to bend and flare. Has...
The Copper Nickel lines are supposed to be alot better than Aluminum. https://www.amazon.com/Roll-Copper-Nickel-Fuel-Transmission/dp/B015YGREXU
PI*R^2*h...
Upgrading a stock block is not cheap, but there are not that many alternatives currently. With the girdle, you will have to figure out the...
Found a picture of the BCR aluminum caps and girdle on the engine.[ATTACH]
On my 400, 4.15" stroke, 12.4:1 compression, Edelbrock Victor MW headed, 0.726" lift cam engine, I used the BCR kit with aluminum caps, 1/2 thick...
Looks like this is an older post. I was going to say to list the valve spring setup too. Some valve spring retainer combinations can get pretty...
That's about where I was at before the new engine (12.50s @ 110 MPH). The new 500" Stroker is making the 60 foot worse because lack of traction /...
On the '71 Charger the rear spring pack had an extra leaf added (both sides) that sits right under the main spring leaf, and extends forward...
Part of selecting MW is they are pretty close to where I live. Supporting local business
