Separate names with a comma.
I’ll forward my address to ya so they can be shipped to me! Lol!
Just west of Fresno. Run what ya brung! Dusty as hell, can’t say that enough.
Just found this......
I’ve heard that trans coolers also have a temp valve? that doesn’t let fluid flow until it reaches a certain temp. Do not take that as gospel.
A single 2 speed fan works great, especially if you use a PWM controller. I installed one from Rainbow Products with their controller on a 6.1...
How does one go about getting their car in for testing?
As long as the backlash is around .005-.008 and rotational torque is around 20-23 inch pounds, I’d run it.
I know Vince the owner, good dude.
Did you use Fearless Gear in Fresno?
I used the factory bolts on the rear to center k frame.
So what’s a Lexan windshield gonna weigh?
Your on the right track, no pun intended. I’d also get the QA1 adjustable strut rods, free’s up the up/down movement of the lca.
I don’t see them on his website anymore, but a guy over on FABO got some and welded them on. Not sure when this happened.
Dr. Diff at one time made stand offs to weld on the 60 housing so a pinion snubber could be used.
Same here. That included new 35 spline axles with green bearings.
Dana and your set.
I doubt it’ll make any difference.