Separate names with a comma.
You don't need to go stroker!
You can get good power out of a small block ! Big blocks make the car noise heavy . I always go small block .
Is your car a race car it driver? Sounds like you just drive the thing !
I've used az timing chains before in my daily 74 charger
I'm scared shitless about cam brake in. I smoked a new cam in my early years . Haven't done a brake in since.
I'll second that truck part ! Got any measurement s to be 100%
I can't afford!!!!! So Christmas is coming if one of you wanted to gift one!!!
I did it once in my daily driver when I wàs a poor kid (well poorer and younger) everyone did a posi burn out as I went peg leg ! Worst thing I...
Oh my God!!!!! What a beast !
There's another thread about aluminum heads paint or no!
They mentioned a product that will seal the aluminum so it doesn't oxidize over time!...
Ring looks cracked from here!
Just get a new ring gear heat it up evenly and wack it in place !
I did this many times on my car equipment! And...
Well not what I was expecting!
At $500 id take a gamble the repair doesn't look bad I would go get it dipped and really look at it to see if it's worth investing into hemis are...
Does the shop offer a warranty? What did they say ?
What's the plan for the 3 speed stuff ?
My dad had a 3 on the floor Chrysler Newport as a kid we own a Chrysler 300 now and it might be cool to...
Big block and good mpg don't go together!
That being said
My 64 Chrysler 300 has a 413 in in .
Not a power house but say 300+ hp under 350 and...
What is the problem exactly yokes don't usually need to be replaced and it looks dry
Are they just wanting to replace the u-joint?
A reseal is fairly easy and str8 forward if you can't find anyone give it a try you will be surprised how easy it is
Stick one bolt in tight and turn it over to all 3 others if they are off try again the next hole over ! Just get you plugs out to help turn motor...
Wow that's some screwed up stuff going on! Glad I got a driveline shop I trust that's never caused me any concerns
I get car high enough get trans in position put the lowest profile Jack in the back then tilt trans forward (tail up ) slid jack Jack in and set...
Post up pictures