Separate names with a comma.
The large part goes to the outside. Use a small amount of soap on the small area.
Make sure the metal housings are grounded very good to the hood. That's where I had the most problems.
My AMD quarters did not have the predrilled holes. Glad I saved the old quarters to use as a reference.
Propane torch with paint stir sticks as scrapers. It takes very little heat to soften it enough to peel off. Wire brush and then mineral spirits...
Gravitex by UPOL. Amazon and automotive paint supply stores sell it.
Wow. Excellent pics and description.
These are the screws that attach the stainless steel trim to the trunk opening lip. Would like to see a pic and dimensions of an original screw....
I used to buy a lot of paint products from Nathan Thomas at JT Davis.
I purchased mine from Instrument Specialties. Two years ago it was $95.00 per pint. I just checked and it's now $199.00 pint plus shipping!
Yes. That happened just a few miles from my home. Now the injured man's family is saying that the city could have prevented the injury.
Ditto on the torch. It takes very little heat to soften it enough peel off like butter. I used plastic scrapers and some paint stir sticks shaped...
Did you use the 3M bedding and glazing compound on the corners and metal body lip?[ATTACH]
Just like the pics shows. No additional strip needed.
I used cheap paint thinner and purple Scotchbrite.
I am looking to purchase a car cover for my '68 Charger. I plan to keep it in the garage most of the time, but there will be times where it will...
The bottom one is correct. The center slash mark is not supposed to be painted.
I went with Instrument Specialties suede lacquer. It is the correct factory finish, but it is difficult to spray and very expensive. I paid...