Separate names with a comma.
If you are running a 4:56 up rear and would like to go to a lower gear , I have a 4:10 thin gear set for sale . This gear set can be used with out...
1 3/4 x 3/4 u joint 1 3/4 x 3/4 36 spline u joint can be welded to shaft or drilled for grade 8 bolt to hold in place . Was bought for my steering...
I have 4 3/8 heim joints , 2 left hand and 2 right hand threads , can be used for motor limiter or turn buckle for engine torque strap . asking...
1978 440 motor block with cast crank from a motorhome . I bought it and was going to build a stroker motor , sold one of my projects and no longer...
Picked this gear set up several years ago with the intent to use in the Dana 60 I had under my 66 cuda funny car . It turns out to be a thin gear...
426 Hemi Hilborn injection intake with billet aluminum stacks . has no butter flies or shafts . has been set up for EFI with the bungs welded in ....
Bought this for a 440 I was going to build . Plans changed . $125.00 plus freight . Sells new from Summit new $297.95 . Thanks for looking John...
1965 426 hp wedge block . Came out of a 1965 Dodge Monaco I bought and parted out due to rust in back half of car . Pulled the block and was going...
Left and Right tail light bezels with lenses for 65 coronet . These have been rechromed but are not perfect . will make a good pair for a driver ....
I bought this shifter 10 years ago , bolted it the trans , moved car from N.C. to AZ . Pulled it back off when I found a Hurst push down shifter...
