Separate names with a comma.
Looking for best way to remove old and then install new heat riser bushings. Thanks
Went out and measured driveshaft for my '65 Belvedere with big block 727. From center of the rear U joint to center of front U joint for slip yoke...
I have one that I am going to put in my 65 Belvedere (swapping to big block). It is in storage so I will have to look for it, but I think it was...
I just finished rebuilding my 65 727 last week, and that was also on the output shaft.
Sounds good Thanks
Do you soak new transmission bands? If so, how long? Thanks
Near the bottom of the pan is a built in baffle with a hole in it for dipstick. The pick up also had a curve in it to fit an indentation in...
Did all 65 B body big block oil pans have a baffle? I have two pans that supposedly are for a 64/65 big block engine. Neither has any number on...
Tried a long bar to turn axle as suggested to align, would not budge. I'm planning to remove gears and look to see if it is misaligned. If so,...
Have trouble getting axles into sure grip. Can I loosen the bolts on the sure grip while it is still in the rear end and if so, do I then have to...
I'm going to get my son and brother-in-law over this weekend to help with trying to get axles in using pry bar method to align sc clutches. If not...
Clutch style
Removed O ring like Glenwood did, but axle still would not go it. It must be the sure grip splines need to be aligned. I'm just going to remove...
I also thought that if they went in with only 1/4" to go that everything would be lined up. Am I wrong to assume this? The housing is a 65, and...
Fran Both of my axles will go in and turn yoke, but will not go in all the way. It doesn't matter if I just put either side in or both sides, same...
Sure grip was rebuilt and same pumpkin just with 3.55 gears
Having a problem with the installation of my axles. Pulled axles and was going to install new gears and rear disc brakes. Installed green bearings...
I see that people have changed their axle studs to Dorman's 610-103. Will these work for rear disc brake conversion? Thanks
Having trouble removing the park cable from the housing on a cable shaft 727. I loosened the pin, but the cable still won't budge even though the...
Anyone install a shift kit into a 1965 cable shift 727 with front and rear pumps? If so, whose kit were you able to use? Thanks
