Search results for query: *

Nice 68 Charger

I’m upgrading my 63 manual brake car to a dual master cylinder. Can I reuse the push rod out of the single master cylinder, or do I need to purchase a push rod as well?

Dave, maybe one of your retired friends can help you :poke:

Home project? Pull all the freeze plugs, and pressure wash. You might be able to do it at a diy car wash, but a pressure washer around the house has many uses.

Agree, the headliner will be installed pre glass, I’m just not ready to do the vinyl roof yet, I want to drive the car around without for a while in case I prefer it painted, if I lived in the US I’d take the glass out to install the vinyl roof however as I don’t, the risk of glass damage is...

Similar to MSD box, comes with ignition box, flamethrower 3 coil, wiring harness and hardware. Brand new in original box.

It looks like Earl really knows what he's doing. He would do mine, if I couldn't do it myself (I can). And since your concerned about breakin with a flat tappet cam (frankly, an rv cam should be an easy breakin) I'd ask Pat about what he would charge to break in a motor EYE built. You probably...

3.59et @ 350mph, it's coming sooner or later NHRA (for insurance reasons) they'll restrict RPM (it's at 8,500 now IIRC) or mandate gear ratios or put more weight on them or something to slow them down Pro-stock is limited to 10,000 (or is it 10,500 ?) IIRC, there were guys going near 12k rpm...

Do machine shops still boil the blocks ?

I'd go with Standard brand for aftermarket.

Mopars & Melodrama :rofl:

That was pretty much my same process last week. '70 Charger seatbelt restore After a scrub with plastic bristle brush and Dawn dish soap, a rinse in hot water, a bit of time to dry, then I dipped the metal buckles in some WD-40 to remove the moisture. I let some parts soak in EvapoRust to stop...

If there's a line for food, get in it.

Duplicolor Engine enamel has a couple of blue colors. It's been holding up on my drums for a few years now.

Quite possibly has one of my driveshaft’s.

I'd hesitate to do any kind of polishing on plated ABS plastic. That plating is very thin and you're most likely to expose the bare plastic beneath.

Set of TTI small block step headers ceramic coated in good slightly used shape, few scratches and one ding from prior install. Will fit B, E, F, and M body according to TTI site. Not on this site much but am well know on for a bodies and goblue9798 on ebay with 100% feedback rating.

congrats to @Outlawd for the qualifiers picks congrats to @GTXDAN for the eliminators picks mineshaft air there, not too hot, relatively great track Prock going 340+ & Force going 343+ mine -1 Anderson in P/S went out early (I was surprised, bad tire shake, whole KB/Titan team went out...

Pressure and ohm test before install. Just like a fuel gauge, 74 ohms is zero and 10 is full gauge. First one I installed was a dud.