Most of them.....pthalate esters are "seal swell" chemicals + pthalate esters are often used in DOT3 brake fluid....not necessarily the exact same...
In general, these type of "seal swell" products contain chemicals which are slightly incompatible with rubber & make it swell. It doesn't really...
No column is better than the factory column in my opinion. Just put in a new upper bearing & lower bushing + buy a "no column shift" collar from...
If you want a factory "slap stick" shifter & console, then you need to remove the "4spd hump" & block it off (a patch from another tunnel or sheet...
What headers do you have now? When I used to run the 2" primary big tubes, I found that I got about 2" more ground clearance with Hooker vs. Heddman.
In my humble opinion, it depends on how fast you think you'll go at the track. I believe a roll bar is required on a hardtop at 11.49sec/quarter...
It has to be easier & cheaper than swapping a k-member
Tim, with your background I think you can answer this question better than any of us...seriously
It's up to you, but keep in mind that tires are bad after 5-6 yrs. (?) or so regardless of how much tread is left on them... the rubber just...
They do sell electric remote bottle openers... it would take 2-3 seconds, so maybe that's too long a wait. For an extra $10,000 you can build a...
My 2-cents.... if you want it run EXACTLY like it does now, go with the giggle gas. Just some pistons & a little this-n-that and you'd have what...
I'd ballpark a 383 long-block core at around $400-$500. I honestly think you should rebuilt what you have. Turn down the crank if necessary,...
Freaking incredible Joe.....beautiful car!
pistons? rods? crank? block mods? cam specs? carb or efi? If carb, what mods? Anything else "unusual" you had to do to set it up for a procharger?...
Nice car! Can you give us any setup information? I'm sure I will never build anything in your league, but I keep thinking about doing a...
Yeah, carry a 5-gal gas can for a little while + a funnel with a long snout. What is the gage doing or not doing?If the gage stays on "all the...
Sounds like a super-cool car! The only thing I would mention is that the '03/'04 Cobra independent rear suspension rear ends are know to break....
As you know, the '71 seat belts were retractable.... but I'm not sure what was up with the shoulder harness. I had a '73 Fury that was...
Sorry if I'm mentioning things you already know. I would suggest a set of stock diameter big block torsion bars which you can add later. The car...
Separate names with a comma.
