Separate names with a comma.
Needed to clean this hood up. It was nasty. Set it up and filled it with a mix and pressure washed it off a little bit ago.[ATTACH]
I like Centari
I just washed my heater box with hot soapy water and a sponge and it looks like new. Still retains the shine of a new part. I will try it on my...
SnakeOil where do you get the bridge paint?
I sand blasted, used self etching primer, then topcoated.
Thanks Photon. I sent him an email.
I could use 1135S also.
I went to the place I always dealt wih and he you can't get it anymore and the new poducts are 2 part instead of three part.
I found an unopened gallon of DuPont 1140S uroprime and two quarts of 1125S. I need a gallon of 1130S urethane thinner and its been discontinued....
That wheel cleaned up nice!
Here is another set i'm working on. These were a little bit rougher than the last set and so far i've been unable to get the bleeder screws out....
Took this picture 7/25/14. Think it was in the sauce about 7 days. Nice way to strip parts. Thanks Photon[ATTACH]
Rocket's look like that also.
I;m cooking a set of brake calipers right now.
I get all my suspension components hot tanked before I blast and paint them. Its a whole lot easier.
I paint all my frontend component parts and pieces in POR after they are blasted. It holds up good and doesn't lose the gloss since its never in...
I weld mine solid, even on cars with original quarters, fiber type filler, then all-metal or bondo.
where can we find the documentation???