Separate names with a comma.
Did the filler tube press into the rubber ring on the tank?
I've done some kinky things naked but never installed a gas tank that way. :carrot:
I've heard about the painting before because of porosity.
Inside my old tank. Looks like varnish and probably lead deposits. Bought a new one. Seam was leaking too.
So you're not working on a Charger?Be extra careful with the lye. Outside with a respirator. Watch mixing different chemicals.
And try to save and reuse the retaining ring. The ones that you get with the sending unit are quite thin and flimsy compared to the original and...
In a way, I like to crank the engine several times for pre-oiling. My engine starts so quick when the carbs are full. Useing E-free most of the...
And your antifreeze doesn't have to be 50/50. I would dilute it for around 0*F. Not sure what ratio that would be. Thats where mine test at. The...
Bad pickup modules are known for the "won't start when hot". Even the newer cars will have this problem. Let it cool down and it starts again.
Check your timing!
That didn't take you long! Sounds great, looks great. Your linkage and fuel supply looks nice. Great looking car also:thumbsup:
I'm liking the new design. I wonder if the older carbs could be upgraded with the boosters.
I went with the 1405 and a manual choke on the rear. Removed the choke plate on the front carb. The 1405 has a heaver needle and seat on the...
I'm not a TQ expert but there is a lot of info and videos on the net on rods, jets, springs. Google "Thermoquad" and have at it.
You might want to get one of these. Makes it easy to hook up throttle cable and kick down.[ATTACH]https://www.summitracing.com/parts/edl-1481/
Sorry 64SF, I stated they were 1406 but they are the 1405 Eddies.
I have no idea. You would have to know the center to center measurement. If you were really gung ho on useing that particular air cleaner, a new...
The Factory cast iron has the carbs closer than the Offy. This is the factory cast iron on my BB. The factory oval air cleaners almost touch.
If it's starving for gas it could be a loose eccentric on the cam gear that operates the pump leaver.You can run an electric pump with your...
That's only if you can't get enough throw out of the linkage. It should work fine in the center hole on the leaver. Make sure the "S" hook is in...