Search results for query: *

Ok good. Why do you want to get rid of the green bearings?

Don't think a drag tire will work in well the rain, they won't. You will need to drive very carefully with them on your car. They are legal, that's all. They are not a well rounded all season tire.

Many of the mopar decoders are for car parts only. my A100 727, radiator and distributor are not showing up in them, so I had a friend look them up as he has many books. They are light truck parts only. I bet Glen-ray is at carlise making a living. Your Top tank could have been swapped...

There is a nut on a stud underneath. Wire brush, penetrant and time are your friend. It has been in place for 58 years now.

Yes the bearings interchange on stock axles. Will they on moser axles? Don't know but seems like they would. Big question, does your differential have the centering pins inside? They stock axle bearings must have the center pins in place to adjust them and prevent leaks.

They are great cars. Drive very well. You will like it! 1355 67 RT 440 4 speeds made 8472 440 automatic made

Take of the belt the spins the fan, then the fan will be still while you turn the crankshaft.

What engine? that pully is different depth for SB or BB

Studs and nuts with captured washers in ends, bolts in the 4 others.

Great car, enjoy it! They finally got it right for the 1970 Charger! Best options also: 440 6 pack Pistol grip shifter High back bucket seats 15x7 wheels Dual racing mirrors Electric headlight doors Key on column Door scoops

Do you have molded carpet? You place it on the floor and slide it rearward until it stops against the rise in the floorpan for the back seat to sit on.

I don't know which step it should go to. I've not noticed it going to the top step. You adjust speed with the screw. It seems nothing on the choke or fast idle goes to the end of the range. Any settings or screw turning, there is always Rome to adjust. If you adjust the choke thermostat...

Good job making those parts into a car again! Good choice on colors too.

No way to do it, must remove the plastic headlight bezels. Don't need to remove the grille.

What does low mileage mean? 30,000 on an original engine?or 2000 miles on a rebuilt engine? The age could have hardened oil inside lifters. Yes take them apart and clean. Wont hurt them. They need to go back together with same internals, ans on the same cam lobe, don't mix them. Pre oil...

Is this on new pavement it wanders, or old pavement with grooves? Look for loose parts first. Measure the toe add make sure it is toe in, if zero or out it can wander. You don't need that much caster to have the car drive great.

How much does one of them weigh?

@toolmanmike What year of mopar uses 3/4" heater hoses? I use the cutter shown above. If you need to cut off 2 inches of hose you can cut one inch off first to practice and see what works to make a straight cut. What is the engine size you are working on? BB has a 1.75" lower hose, SB has a...

Welding will leave blue marks in the chrome, guaranteed!

Charger looks Great! I would take the top off the 4640 and make sure the screws are snug and the needle are tight where they screw into the top. Check float level also. Then,put it an and see what it does. They don't really go bad from sitting unused. The accelerator pump plunger may or...