Search results for query: *

I did it and it works!! I figured out how to wire this up and finally got up the courage to cut into my brand new wiring harness. The install is nice and neat to boot. Here's my wiring diagram for anyone else who may want to wire in the 2 step and line lock to release on the clutch dump. I may...

I ordered a similar set from Brewers

yep, used a dial indicator marked in .001 increments on a magnetic base attached to the back of the crank.

Hey guys, I mocked up my Lakewood bellhousing to check for runout and here's what I got. The top is +.012 and the very bottom (hard to see) is -.002 I removed and remounted the dial caliper and checked it a second time and got almost exactly the same thing. From this I should be getting a...

pm'd

Sure. I can trailer it a few miles

Hi Guys, I'm looking for a shop near me to finish up the restoration of my 71. looking for rear quarters to be replaced, body to be blocked and painted, headliner and vinyl roof I don't want my car to end up in body shop jail!! Hopefully someone who can do it over next winter

Great idea!. I just ordered a can of it. We'll see how it does Thanks!!:thumbsup:

Disney/Discovery f**ks up another great channel. I've been watching Roadkill and the other associated shows since they first started streaming on youtube 12 years ago. Great business model Disney. Buy great content then kill it with gross mismanagement. 'Roadkill' Is Finished as MotorTrend...

the housing is grounded fine, it's the socket to the housing

Hey Guys, I've been having an intermittent issue with my front drivers driving/blinker light. The bulb socket is pressed into the pot metal light housing using that press fit/swedge to ground the socket. Over time corrosion has built up between the socket and housing. causing an intermittent...

Sale pending

For sale is the 8 3/4 I recently took out of my 71 Charger. Fits B bodies from 71-74 (stock dimensions) It is complete drum to drum 489 center section with cone type sure grip crush sleeve eliminator kit Richmond 3.55 gears forged 1350 10 spline yoke from Dr Diff Green bearings Pinion Snubber...

It only has one at 4-1/2 x1-3/4 which isn't tall enough

Thanks for the link guys! The only issue is my mirror isn't round, it's oval. I think I may stop by a local glass shop today and see if they can cut something that will work.

I purchased a pair of OER sport mirrors for my 71 Charger. They look great but the passenger side mirror is kinda useless. The glass is not the convex type (ones that usually say objects in mirror are closer than they appear) It's regular mirror glass so it's pretty much impossible to see much...

Funny you brought this thread back up. After many many hours and many many $$$ I finally figured it out.... It was the f**king pistol grip shifter handle!! The plastic pistol grip handle along with the Hurst competition plus shifter rattle under load and higher RPM's It had to get a lot worse...

Out with the old and in with the new

I paid $500 only 3 years ago for a brand new 3" driveshaft with 1350 U-joints I just checked on Dr Diff's site and it's still the same price.

I have no doubt but...damn!! what happened to the days where you could get it done for under $100 used to be 2 or 3 shops local to me that did it. Now I have to travel an hour. I sense myself becoming an old curmudgeon with every key stroke.