Search results for query: *

Thank you looks like they have what I need.

Yes take a pic of the orientation

Why do Kiwi's have such a great historical reputation in racing?:brownnose:

Who was the first (and only) person to hit a golf ball anywhere but Planet Earth? Of course everyone was yelling out Neil Armstrong, Buzz Aldrin etc...... I waited for the shouting to die down and said Alan Shephard. :) The room went quiet; I went up on stage and was asked how the hell I knew...

just tried this and nothing happened. i may try to replace the fuse first and see if that helps

Sale pending

So what was the question?

When remove the trans crossmember the whole thing will tip down in the back. Be careful with the harbor freight trans jack. Coming down they have a tendency to just drop. Keep fingers and any other body parts out of scissors area just in case. Once trans is out modify mounting plate for shifter...

That is a very nice article.

My first concert was Ozzy, a few months before Randy Rhoads passed away. RIP Ozzy.

Are we assuming here the struck car or its surroundings were not hard/reflective enough to bounce the ball back in bounds?

Looking for a set of Asbestos lining 11 x 2 1/2 rear brake shoes for my 69 A12. Craig currently has no inventory. I don’t care what brand or if they are re lined as long as they are old school asbestos linings. I think the bendix number was a 446 shoe. Thanks Dan.

When in doubt, it's customary to do it at TDC and realign as outlined in the FSM.

Do not need to remove trans.

It was a tongue-in-cheek comment....but I hear your laughter anyway. I have put my fair share of balls out of the course of play - hit the side of a house one Sunday morning - put a hole in the asbestos siding. We could see the ball on the ground, and my buddies couldn't stop laughing...

Use a flathead screwdriver, stick it in the slot, and twist. It'll raise up above the cam gear, then use a magnet or needle nose to pull it the rest of the way out. Be sure the intermediate shaft goes back in with the slot pointed the same direction.

Well dang it I'm back again with another question. Tried to pull the shaft out and can get to wiggle up a little but not release. Does the engine have to be turned to move the cam teeth to release it? I have some long nose vise grips on the rim of the shaft and they keep coming off.

and they would make a great addition to the Dork-Dish crown to be worn at the FXBO Tent in 2026. :lol:

If Ronald McDonald had a Superbird replica.... :lol: