Search results for query: *

Dab of pure dawn, big dead blow hammer, little blood and some choice words and the plugs are in. They went without modification but you have to swing on them hard. I just pretended the plug was the guy that invented them and swung away. Thanks for all the replies. Dennis

Hi Finally getting to the task of installing these body plugs into the new AMD floor pans. The larger plugs went in pretty well but now I’m trying the smaller 1” plugs. Can’t get them pushed in. The holes measure around 0.980 and the plugs around 1.175. Any tricks or advice is much appreciated.

No it’s a thin plastic insulator on the steering wheel itself. I don’t have a picture.

My 70RR has it

I’m pretty sure it’s double stamped for a reason. One is the keyway slot and the other is the tooth notch. Example if you want to advance it two degrees you would use the A2 keyway slot and then line up the A2 tooth notch with the top gear marks while installing. Been a few years but I’m...

I went through a couple of deep sump pans until I finally made a skid plate from the K frame to the scatter shield bell housing. That put an end to that aggravating problem.

Thanks for the help everyone. I found some online and got them headed my direction.

Thank you

Bought these new tracks for my 70 RR bucket seats. The wire going between the rail latches is so long it doesn’t release the inner rail latch. Seems like I’m missing a tensioner or something to take up the slack. Can’t find it in my FSM. Any help is appreciated.

I would first put an ohm meter on the brass ring and steel splined area and see if it’s actually making contact. I’m not sure where to buy a new one of those insulators. I had one I stole off of an old steering wheel. Also if you do change it be sure to mark where that signal canceling rod is...

My 70RR did this exact thing. It was definitely the plastic bushing was cracked. Replaced that and everything has worked right since.

Where can I order your mega kit?

I think it was about $30 for the part and $20 shipping

Non- corrugated cardboard would be my best guess as a description.

Thank you. That’s the info I was needing help with.

I think I bought this from classic industries. The picture on their website looks like it’s tan but it came black like it’s supposed to be.

Thanks for the reply and picture. I think my frame is pretty straight I’m concerned with the part that would hit the back of your knee while sitting on it. Yours looks straighter than mine. Kinda hard to see in the picture.

hi, Got my 70 RR rear seats stripped down and getting ready to be powder coated. The front, top edge of the rear seat bottom has 2 downwards curves where you would sit. Were these bowed originally or just sagged from 55 years of use. I tried to circle the area in this picture but it didn’t come...

There are no dimples in the AMD pan. I will just measure and make it like the right side.

Perfect, That’s what I was needing. Thanks for the help