Search results for query: *

thanks

Hi Im doing over my stock 383 with stock crank is part number 2658457 the correct damper? Thanks

Thanks i havent been on forum for a bit

thanks

THANKS

Hi I want to know if there is a filler to fill the small divots from rust on the leaf springs. I sanded them down and was thinking of using bondo to fill the pits and sand it down flush so there would be filler only in the pits I ;m thinking with the flexing of the springs it may just pop out...

Hey Thanks for the info Test results all were about 100 per cyinder Engine was pulled out and taken down to block Pistons had scraps along sides. Maybe previous owner ran winging with out air filter Doing total rebuild now Thanks for info

Nice.

Hi Just installed new trunk pans. Had to get two halves and installed them. Did puddle welds like 2.5" o,c to mimic the original spot welds then I sanded down welds flush 2 questions I have I assume that the correct way to finish the trunk is to see them hints of puddle welds becuause I...

Hi Anyone know what size drum was stock on 1969 roadrunner 11x2.5? sound correct? Thanks

Hi all Maybe Im doing something wrong I installed my 4spd trans in with throw out bearing on Im trying to get clutch fork on but I cant slide it behind the throw out bearing and into the clips. The throw out bearing is already up against the clutch Am I supposed to back out tranny now and...

Hi What color is the couple and shaft from couple up towards the firewall I have seen them black or natural metal. The books say could be either. Dont know whats right

Thanks I know the pump and pulley above are black. Wasn’t sure about lower steering box attached to the k Member Thanks

Hi Just wanted to know if the stock steering box is a natural metal finished or was it painted black from factory. Thanks

Hi Can someone tell me how many leaf's make up the leaf spring assembly on both sides of the car My roadrunner (8.3/4 rear) has aftermarket leaf springs. Im changing out the lower leaf with an originally stamp leaf with part number 2539213 Are both sides the same with the amount of total...

Hi Im restoring the rear end of 1969 8.75 rear. while Im doing this, I need to change out the seals since there is evidence of liquid loss. Any one know any good seal kits to purchase? Also Im attaching a few photos of rear. The passenger side of rear doesn't have a retainer clip holding...

nice

holley numbers are on front of carb. top right side

I think I may just cut out lowest pan area becuase its only bad in lower grooved area that way I keep factory welds I will clean it up and see Thanks

Yes I think that is best. Unless you can put a rachet strap around a one piece and curl up sides to fit through the caro area. I know people have said that is doable but Im not sure