Search results for query: *

Pistons.

Easiest way I found was to work backwards. At the connector where the engine harness connects to the forward light harness, you can pull it apart and put 12v directly to the feed wires on the forward light harness side and see if they open and close. I think it’s the red and purple wires. I used...

I disagree about 66/67 being heavy cars. A 2 door "23" body 66/67 is light as hell. Almost as light as an A body. ...but the 340 was introduced in 68. 71-73 RR and Charger 340 cars could have 3 or 4 speed manual trans not all 727. 71 through 73 came with 8 3/4 axle. Sometime in the 7-74...

452 ported and polished heads, long tube headers, high vol oil pump, torker intake, various tq carbs. Pistons well below deck height. Question is: replace pistons,8 pistons and $120 per hole, or remove meat from top of block? Thanks Guys.

Is it the same as on a '70? On my Charger, the headlight doors have an adjuster screw that limits the rotation, and the screw end butts up against a rubber stopper when closed, like pnora said. The adjuster screw is the silver one in the foreground, I had to install longer ones because the...

I like to copy Pypes “hybrid” system, 3” head pipes off the collectors, 3” x pipe and neck down to 2.5” at the muffler inlet. Then run dynomax ultra flos, 2.5” offset/offset will be the quietest.

almost 6 years now

I ran a jumper wire and they still didn’t close. I’m not getting any continuity open or closed.

I can’t blame anyone for running an older vehicle with the emissions repairs hitting the roof and dependability in the can and initial upfront cost above all it doesn’t make sense .. if you take care of it, it will pay for itself, gas or diesel powered.

These guys were a source for some extra carpet: Classic Car Interior Parts & Accessories | Newark Auto

Mickey Thompson M/T small block LA engine valve covers, aluminum. Straight and in excellent condition. Great way to stop leaks from 50+ year old stamped steel valve covers that have been bent, over-tightened. I bought them to replace the valve covers on a 318 V8. I never used them because I...

I would have to elongate one bolt hole right?

I only have pre 72 staggered bolt pattern. But they are non pitted, blasted and painted- $30

First trip out with this car, not 3 miles from home and I took a rock from a dumptruck. I was sick, the paint on this car was flawless. Luckily, it hit the cowl vent and while it did chip, it was easily fixed. Could have been much worse. Not to minimize your pain, but just a little...

They didn't but someone must have. And back to 1971 B-Body's as stated 3.23's 3.55's and 3.91's were available.

Axle and housing narrowing and shortening | Dutchman Axles These guys are in Idaho. Website looks legit.

34 I was not interested in a "starter home". I also had a list of four things that I would accept any three of, and three things that I would not accept at all. Despite that, I went through four agents that kept showing me three houses that either did not have 3 of the 4 or had one of the...

I wish I had done that with my 2002 pick up when it was new. The frame looks worse that the Titanic.