Search results for query: *

As said earlier- they didn’t. My car was originally a 318

My back.....my back! Oh, wait- your back....

If you don't have 12v on either wire to the override switch then the problem is further upstream.

Wasn't that outfit at Carlisle the other year trying to drum up orders?

Trouble there are 2 different types of Carter factory fuel pumps. one has option of hard line to the carb, other doesn't,.

The first time I saw one of those circa 1979, I suspected this and just about 10 years ago it was confirmed- was the inspiration for the Imperial Star Destroyers in Star Wars. Confirmed by George Lucas himself.

Fine Italian gin and it comes in a qt oil can Gin and tonic

You can only deck the block so much. Have it decked to square and new pistons. Smaller chamber heads a bandaid for the short term.

Replace pistons is the better way to go. Intake manifold still fits, overbore cylinders and have great ring seal. Maybe spend some money on some quality lighter pistons. Must take it all down to nothing to machine the block deck surface.

Nice. From the factory, the center filler extended under the corner fillers about 1/2 inch. There is a molded step in the corner filler to accept this.

Never used them good luck I did buy a lot from https://www.automotivetouchup.com colors was great, could get in arenol cans or pints or quarts or gallons too, all the reducers or thinners etc.

Today

Pistons.

Easiest way I found was to work backwards. At the connector where the engine harness connects to the forward light harness, you can pull it apart and put 12v directly to the feed wires on the forward light harness side and see if they open and close. I think it’s the red and purple wires. I used...

I disagree about 66/67 being heavy cars. A 2 door "23" body 66/67 is light as hell. Almost as light as an A body. ...but the 340 was introduced in 68. 71-73 RR and Charger 340 cars could have 3 or 4 speed manual trans not all 727. 71 through 73 came with 8 3/4 axle. Sometime in the 7-74...

452 ported and polished heads, long tube headers, high vol oil pump, torker intake, various tq carbs. Pistons well below deck height. Question is: replace pistons,8 pistons and $120 per hole, or remove meat from top of block? Thanks Guys.

Is it the same as on a '70? On my Charger, the headlight doors have an adjuster screw that limits the rotation, and the screw end butts up against a rubber stopper when closed, like pnora said. The adjuster screw is the silver one in the foreground, I had to install longer ones because the...

I like to copy Pypes “hybrid” system, 3” head pipes off the collectors, 3” x pipe and neck down to 2.5” at the muffler inlet. Then run dynomax ultra flos, 2.5” offset/offset will be the quietest.

almost 6 years now