Search results for query: *

Probably not a valid solution, LOL. I've got an aluminum center with a spool for my nine inch, and it surprised me how little weight was saved. Even without a lsd, it's still not "light", just lighter.

Where is the main switching transistor located?

I’ll try that

Thank you! Good tips. With the old carrier out, do you see any issue with using the rear end to pick the car up further with a jack? Not sure how much structure the carrier gives the housing.

:fool: :fool: and you'll forget all about your back :D

Just saw an ad from my local dealer, $16000 off a new 2024 crew cab Ram. The ad conspicuously did NOT mention the engine.

You could put the stands under the front spring hanger area and let the axle hang down. That may give you the room you need.

My local dealer still has a couple new 2024s available with 5.7s. STILL too much money! I think they are still asking sticker, since the hemi's went away.

Hey Bob, I didn't see the word "ethics" used but I did see "etiquette" used after you made mention of "specifically some Spanish person that knows nothing but pretends he does as his own work". Now, you have said your piece, so scroll on and leave this thread alone. Entender?

I'm surprised no one has brought it to their attention in the past.

They're doing it, " Froggy Style"! LOL

Yes I have 6 ton stands. Right now they are under the axle not extended. I can probably first try lifting the front and putting my ramps under there tires to see if I can roll the carrier in up towards the front. I don’t always feel good working under stands extended too far.

I just read through this. Looking at the pictures you have a 5 pin ECU with a 4 pin wiring plug and a single ballast resistor. So no power on pin 3. Perhaps it had a 4 pin previously which failed and an attempt was made to replace with this 5 pin. (Just guessing but I don't see how it ran in...

It is possible that the main switching transistor is / has failed. This transistor is external and is a power Darling design capable of switching coil's primary current. If the transistor has failed, either failed open or shorted the resu,t is an intermittent spark or no spark...

...size dish cup) then rolled it under and could adjust the height with only the bottom half of jack handle. It was still a struggle but doable and much safer than trying to bech press it up and in: 3. *Tip I used a 1" x 2" strip of wood to hold the driveshat up out of the way above the mufflers:

PM sent

Use an Aluminum carrier?:lol: