Search results for query: *

With the setup on Jack stands, I measured the overall width of the “Track”. I’m getting about 74 7/8” overall. Now, the width of the car. Using a 4 foot level, I ran it plumb down from the body and then measured IN to the inner edge of the wheel well flange. The hash mark is the plumb...

Patience is sadly a virtue when it comes to these damn things. Imagine taking your car all the way down to this point and then still trying to stay motivated to carry on with your project. Don't let it beat you down. The minute you get frustrated, just walk away, even if just for a few minutes...

No one seems to be listening... Like the man said, a gray/brown tone with visible fibers....

Appreciate the help to all! My situation is I have 2 outer pieces originally 69 and the Center section from a 70 which some one painted gloss black used paint remover to remove old paint ! Know originally it was a brownish as Dadsbee said I am not going concourse! Most what I see at shows have...

When trying to see if a non stock replacement part will fit, there will be some trial fitting or Mock-Up to do. I could pull the existing B body axle out and test fit this Van axle or I could do it this way…. I’m going to assemble the axle…. With the following parts…. Third member only...

I ended up getting a new driveshaft with no ring, the old one was too dinged up to save.

I run either Champion J-10Y or AutoLItes 85... Just my $0.02... :thumbsup:

Richard Cranium--where did you get those shoulder belt clips?

Also, It might help to work on your body lines first and see how the gaps land. The bottom of the fender needs to come out. Its going to take a few hours per side just an FYI.

Start a "What's it Wurth" thread

I am greeted every time I go to this one site......by Security. :lol: They growl, bark and sniff....then sit down again. Just like a Security Guard. :poke:

1968 Dash Bezel $90

Only 2 small dents

And why not make the hardware store parking lot a little cooler while I’m out and about

Couple other pics. He apparently sucks at taking useful pictures

1968-70 Quarter Pad Bolsters. Pair $100

https://va.media.tumblr.com/tumblr_t0m6bseIFY1ymr41e.mp4

BTW, what ever became of the DS inertia(?) ring?