Search results for query: *

A pic of knob & radio knob would help

But looks to have a very fine clocking index, and once you raise the wrench off the hex, you should be able to remove the wrench, if one used the open slot to place the wrench BEFORE tightening, vs lowering over the stud? Meaning if you got it on, you should be able to get it off, unless I am...

A few more Mopars, mostly A bodies.

I was looking online for a new ignition module. When I fill out my car info on several parts sites, it says it will not fit my car when I select what I believe is the correct module. Mine is a 5 pin module(see pic), but the sites seem to think it should be a 4 pin module? Any input would be...

I was back at our local cruise last night. My buddy brought his Bullitt Mustang and his daughter brought their Hellcat. Her fiance brought his Nissan GTR which has been tweaked to make over 700 horsepower.

It wouldn't hurt to give it a good look while the engine is out. The service manual has measurements of the unibody. It is possible that the whole front clip was replaced.

Found on and bought off flea bay - minor blemish but better than what was on the car (2nd pic)

As noted above, the rear Shackle mounting point is 1" farther back on a dodge.

Awesome pictures. Thank you for sharing

Memories

I have a couple fully restored grills and headlight surrounds; I will only sell as a set. Not cheap. Not sure what you are looking for?

The good 'ole daze!

Thanks - that looks red.

So you do not need to connect the 3-pin connector to anything?

What a great run he had! R.I.P Robert!