Search results for query: *

Too bad there wasn’t some way for the police to sell the parts and make the victims of the thefts whole. That’s if they even knew who they were?

Possibly, all my wiring was hooked up when I was looking for "key on" power. I "think" it's the last terminal/fuse - the only one that's single.

My 500 cubic inch 440

I was searching for the correct place for the third line coming from the breather and your thread came up on my search. On someone's suggestion, I have had it on port on bottom of carb for the last 10 or 12 years. I think I have figured it out now,but came across this and thought I might get a...

@Kern Dog you said you had some blade connection mis-match, but now you've got the new bulbs in. Did they actually work or did you need to do some re-wiring or buy the H7's? I'm confused (as usual...)

Note to self: insert the thumb, first. Who woulda thought? It may be useful to those with their thumb up their a$$.

My 77 Aspen

WTF did you say ???

Congratulations to 'Sublime one' (FABO) for grabbing the -1 Pole Pick bonus point this week. He was the only one to pick #22 Joey Logano to be on the Pole at Loudon.

Today I put the steering coupler in place, installed the roll pin. Column is back in place. Counted out the turns right to left, 3.75, went halfway back so I can load up the under pinnings tomorrow. Pulled the old upper arms off. Bushings were about done like I figured. FF arms are in. I made...

Ha, good point, but I don't think distillation will grab the iron oxide from solution. bummer, actually. I'd love to say to my wife, I need to take my iron supplement, and then throw back a shot of moonshine from the freezer. For the record, I DO NOT recommend distilling and drinking for...

If you do replace it, I would also check the pickup

I thought that "O" rings were sized by: outside dimensions (OD) X inside dimensions (ID) X cross section thickness X elastomer type....Viton, Teflon, etc and service extremes.........just my thoughts...... BOB RENTON

Beautiful car, if we were at the same post office there would have been a little competition!

This one is relatively basic. Buckets, console, roll up windows, am radio. No idea on rear end, it was replaced. It has no trick options.

Thanks but sound real $$

I've seen many a 440 oil pan (mostly on C bodies) that look like that, having been driven with the dent for years without apparent issue. The oil pickup is a good 1/2-inch from the bottom of the oil pan, so it takes a significant dent (more than 1/4-inch depression) before I would begin to...

Welcome from the central coast of Cal.